Where is the drain plug to the radiator on a 2000 jeep Cherokee?

SOURCE: drain radiator

How easy is it to remove lower rad hose? I've reverted to that more than once rather than fight with some of those drain plugs & their neat locations.

SOURCE: Radiator fan will not turn off in my 2000 Jeep Grand Cherokee

usually the engine relay or cooling fan relay..!

SOURCE: How to replace sparl plugs on a Jeep Cherokee?

Hello, I hope this info helps...(subytech1)...REMOVAL
In this engine, each individual spark plug is located under each ignition coil.

1. Prior to removing spark plug, spray compressed air around base ofignition coil at cylinder head. This will help prevent foreign materialfrom entering combustion chamber.
2. On this engine each individual ignition coil must be removedto gain access to each spark plug. Refer to Ignition CoilRemoval/Installation.
3. Check condition of coil O-ring and replace as necessary.

1. Inspect spark plug condition. Refer to Spark Plug Conditions.

CLEANING
Theplugs may be cleaned using commercially available spark plug cleaningequipment. After cleaning, file center electrode flat with a smallpoint file or jewelers file before adjusting gap.

CAUTION: Never use a motorized wire wheel brush to clean sparkplugs. Metallic deposits will remain on spark plug insulator and willcause plug misfire.

ADJUSTMENT

Setting Spark Plug Gap - Typical
Check spark plug gap with a gap gauge tool. If the gap is not correct,adjust it by bending ground electrode. Never attempt to adjust gap bybending center electrode.

INSTALLATION

CAUTION: This engine is equipped with copper core groundelectrode spark plugs. They must be replaced with the same type/numberspark plug as the original. If another spark plug is substituted,pre-ignition will result.

Special care should be taken when installing spark plugs into cylinderhead spark plug wells. Be sure plugs do not drop into plug wells asground straps may be bent resulting in a change in plug gap, orelectrodes can be damaged.

Always tighten spark plugs to specified torque. Over tightening cancause distortion resulting in a change in spark plug gap or a crackedporcelain insulator.

1. Start spark plug into cylinder head by hand to avoid cross threading.
2. Tighten spark plugs to 27 Nm (20 ft. lbs.) torque.
3. Before installing coil(s), check condition of coil O-ring andreplace as necessary. To aid in coil installation, apply silicone tocoil O-ring.
4. Install ignition coil(s). Refer to Ignition Coil Removal/Installation.

SOURCE: Trying to drain radiator fluid from 1996 Jeep

the drain plug for the radiator is located on the bottom, passenger side, facing the engine. it looks like a plastic wing nut. it will take several turns before it starts to drain

SOURCE: How to replace spark plugs on 2000 jeep cherokee

TO REPLACE SPARK PLUGS YOU REMOVE COIL PACK MOUNTING BOLTS THEN REMOVE THE COIL PACK WITH BOOT OVER THE SPARK PLUG.YOU HAVE 6 INDIVIDUAL COIL PACK TO EACH CYLINDER. YOU NEED A 3/8 RATCHET WRENCH - LONG 3/8 EXTENSION -SPARK PLUG SOCKET - SPARK PLUG GAUGE.AND TORQUE WRENCH.THE 2000 MODEL JEEPS FUEL FILTER INSIDE THE TANK.1993 - 1996 MODEL JEEPS FUEL FILTER LOCATED LEFT SIDE OF THE VECHICLE NEAR THE FUEL TANK.