Need to remove steering wheel to replace ignition switch. How do I get the steering wheel removed?
SOURCE: installing ignition switch for 87 chevy s10 Blazer 2.8L 4X4
you need to replace the electrical part of switch?If os it is down on column under dash will be two bolts holding on with the dimmer switch also
SOURCE: need to remove steering lock from the column
If you can get someone to help, you can have them press down on the metal lock plate and you can then remove the small wire snap ring on the post.using a small pick or screwdriver. There is a too for this but I made one from a large thick flat washer with two drilled & threaded holes with 1/4 " bolts.(looks like an odd little puller) I adjust it against the plate and use the column nut to depress the unit to access the snap ring.
SOURCE: Airbag removal 2000 Chevy Blazer 4.3l
there should be 2 or 4 bolts/screws on the back of the steering wheel
SOURCE: I am trying to remove the ignition switch from a 1976 Chevy PU
This plate is the steering lock plate.It has a lock ring on the shaft but is under very heavy spring pressure which must be compressed in order to remove and re-install. There is a special tool that compresses this spring.It mounts on the steering shaft threads and pushes on the plate.It is quite difficult without but can be done with two persons as one presses and the other removes the lock ring...good luck
982 views
Usually answered in minutes!
replace steering wheel in a 2000 ford explorer
I need to remove the steering wheel
×