Horn stopped working unable to locate fuse as i have no handbook or fusebox diagram
Hello im looking for a diagram of the fuse box and names of the fuse of my 1991 ford ranger xlt My bake lughts dont work my back up lights dont work my flashers dont work my heater doesnt get hot and i cant find the fuse for these items
no i have a 1991 ford xlt ranger
×
SOURCE: Diagram of 1996 ford ranger fusebox which fuse is
RANGER FUSE PANEL
Fuse Position
Rating
Circuit Protected
1
7.5 Amp
Power Mirror
2
—
Not Used
3
15 Amp
Parking Lamps
4
10 Amp
Left Headlamp
5
10 Amp
On Board Diagnostic (OBD) II System
6
7.5 Amp
Air Bag System/Blower Relay
7
7.5 Amp
Illumination Switches
8
10 Amp
Right Headlamp/Fog Lamp System
9
10 Amp
ABS System
10
7.5 Amp
Speed Control/GEM System/Brake Interlock
11
7.5 Amp
Warning Lamps
12
10 Amp
Front Washer System
13
15 Amp
PCM System/Stoplamps/
4WD/ABS/Speed Control
14
10/20 Amp
ABS System
15
7.5 Amp
Air Bag System/Alternator
16
30 Amp
Front Wiper
17
15 Amp
Cigar Lighter
18
15 Amp
A/C System
19
25 Amp
Ignition Coil/PCM System
20
7.5 Amp
Radio/GEM System/Anti-Theft
21
15 Amp
Hazard Lamps
22
10 Amp
Turn Signals
23
—
Not Used
24
10 Amp
Starter Relay/Anti-Theft
25
7.5 Amp
Speedometer/GEM System
26
10 Amp
4R44E/4R55E Trans./Backup Lamps/DRL System
27
10 Amp
Underhood LP/Map Lights/Glove Box Lamp/Dome Lamp/Visor Lamps/4x4 Sys.
28
7.5 Amp
GEM System
29
10 Amp
Audio System
30
—
Not Used
31
—
Not Used
32
—
Not Used
33
15 Amp
High Beam Lamps
34
—
Not Used 
SOURCE: skoda octavia 1.9 tdi
lods have a problem it a skoda 19tdi no power when i give it the boot 80 km only turbo kicking in ok changed air flow , washed out boost valve, would u think the timing is out
SOURCE: front brake pads 2005 Skoda Octavia 1.9td
I have no idea what a skoda octavia is, but I know brakes are brakes. You have 2 bolts holding the pads in a slide, the bolts have threads only at the top, the rest is the slide, pull those bolts, if that doesn't release the slide, take out the 2 bolts holding the caliper on there, pull the slide out the other way. replace the pads, make sure they go back in the way came out. Put the bolts back on, tighten them up, you should be all set. The pad thickness sensor is just a ground, when the wire hits metal, it turns on a light, It should go off when it is not touching anything. You should have squealers on there too, they give an audible screech telling you it is time for some new pads. Hope this helps.
SOURCE: need diagram and location of fusebox 1988 chevy van G-20
how do i replace the bulb to the taillight of a 1996 monte carlo
1,065 views
Usually answered in minutes!
×