Question about 2001 Mitsubishi Galant

1 Answer

I change the water pump and now the car wont start the spark plug cables went getting any spark how do I fix that

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 5,370 Answers

For spark plug problem, click the help links provided below: ---
Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

------------
How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

-------------
Car cranks, has spark but will not start?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

------------------------
The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

----------
How to gap spark plug ? http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------
Spark plug Replacing for?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

-----------
How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

---------
How does the spark plug wire go on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

---------
Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

-----------

This will help.

Thanks.

Posted on Jun 01, 2012

Ad

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
swoop611

Dave Sargent

  • 488 Answers

SOURCE: I checked my spark plugs and have a spark going to

If you are getting spark and the engine tries to run on starter fluid, then you have lost fuel. Check that you are getting injection pulses at the injectors and check the fuel pressure at the fuel rail at the injectors. Check for power to the fuel pump when the engine is cranking, If you get no power to the fuel pump when cranking the engine, check fuses and relays. If the pump is running but you have no fuel pressure, check the fuel filter and fuel pressure regulator and replace any that are faulty. If the injection pulses are missing, check the supply relay which supplies power to the injectors first ( the injectors are earthed by the ECU) Disconnect one of the injector plugs and using a test light (buy one from a auto parts store) clip the end to a good earth on the vehicle body, switch the ignition on but dont start the engine, then probe the two connections in the injector plug. One of these connections should be active all the time with the ignition switched on. If it is, you may have a sensor failure (crank sensor etc), if it is not, check fuses and supply relays. A word of warning, the wiring you are dealing with is connected directly to the engine control, if you make a mistake, you can cause irreparable damage so if you have any doubts, take the vehicle to a professional..

Posted on Jul 08, 2010

tnymooney

  • 170 Answers

SOURCE: car cranks up but wont start,no fire to spark plugs

FUEL PUMP

Posted on Jun 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a reset for the computer other than unhooking the battery or a reset for the fuel pump?


Could be the pump. Do you have the pressure at the fuel rail? If you have pressure and spark, then the noise you heard was probably lifter tap. No oil or over heated.

Jul 30, 2015 | 1999 Dodge Durango

7 Answers

PT Cruer will turn over but wont fire. Have changed the Cranks Shaft sensor, Cam Shaft sensor, TIming belt and Water pump.


try resetting the CPU program because periods with the battery disconnected corrupts the program which has the immobiliser program in it as well. Use a scanner for this job as removing and re fitting the cable only does half a job and probably will not fix the area that is needed.

May 09, 2014 | 2002 Chrysler PT Cruiser

1 Answer

Turns over but wont start


is this diesel or petrol.if diesel then look to your fuel pump.under it is a plug .remove this and drain what will be water on the bottom of it.only a small amount then refit.now pump the fuel up to it is very hard .then get someone to turn the engine over .as you keep pumping should then start.that is done due to air in the system. if petrol you need a spark plug tester.check the coil has a spark .then check the leads at the spark plugs are getting a spark .then check the plugs for a spark .smell them .do you smell fuel on them .if so change the plugs.

Dec 15, 2013 | 2000 Chevrolet S-10

1 Answer

What cause the car die after i change the spark plug


-Not the spark plug that you just replaced.
-It could be bad crank, Cam., broken timing belt, bad ignition module or blown fuses.
-Check it out.

Good luck

Mai

Sep 17, 2017 | 1995 Nissan Maxima

1 Answer

2000 VW Cabrio Car just stops running while driving and Wont start back up . I have Changed the Coil what else could it be


Mas air flow sensor went on my cabrio, pretty easy to fix, when it went my car would lose power sputter then die out. also could be spark plugs fuel pump, fuel pessure regulator,

Jun 20, 2010 | 2002 Volkswagen Cabrio

1 Answer

Water pump change and now wont start


i just changed the water pump on a 1995 isuzu rodeo and now it wont start///??????? it has spark and i have even tried starting fluid and still nothing ...... what could be the problem

Jan 23, 2010 | 1995 Isuzu Rodeo

1 Answer

My car wont start I changed my water pump n now my car wont start


It is a good idea (recommended) to disconnect the battery when working on electrical components. If you disconnected the batter, make sure the battery cables are secure on the terminals (clean terminals if necessary) - apply a terminal grease to prevent corrosion and acid build up. Also, check the connection on the alternator - it's very possible this may have been disturbed or disconnected by accident during the installation of wires. Part of your message says "my car won't start, I changed my water..." did you change your water pump? There may be a crankshaft and/or camshaft sensor near the water pump. Make sure that these are plugged in and secure. Check your ignition fuse in the fuse box, the starter relay(under the hood) and the fusable link,next to or near the battery, or starter. Check all electrical connection that may prevent the vehicle from starting.

Mar 31, 2009 | 1991 Toyota Celica

1 Answer

Car wont start when it's wet


replace your spark plug cables. Moisture in the air is settling on the spark plug wires which does not allow the spark to travel down to the spark plugs.
Bill

Nov 19, 2008 | 1996 Pontiac Sunfire

2 Answers

Wont start


did you check the fuel pump relays?

Aug 29, 2008 | 1996 Chevrolet K1500

Not finding what you are looking for?
2001 Mitsubishi Galant Logo

426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...