SOURCE: How do I clean throttle body on 2003 Hyundai Elantra GLS?
what u do is go to your local auto supply store and buy throttlebody cleaner you remove the rubber hose from the throttle body with the engine off of course u open the throttle and spray cleaner in it then use a tooth brush inside it replace the hose done
except it will be hard to start the first time crank engine over with foot to the floor on the gas pedal do not pump it
SOURCE: 2002 sonata code P0121 throttle/pedal position sensor A CKT RNG
You need to check the wiring between the ECM/PCM/ECU and the sensor to ensure the sensor is getting the voltage that it should be as well as the voltage it should be putting out. Also check the sensor itself you may have bought a bad sensor. Good luck to you. Thanks for using FixYa!
Sincerely,
JC
SOURCE: Topping up gearbox oil on 99 Hyundai Lantra (manual)
You can actually do it from the top if it is similar to a 2001 Elantra??? On your right center of the tranny, there should be two big bolts I believe a 17mm one on the bottom left the other top right of the other. The bottom left is the drain plug the top right is where you fill it. If you want to make things easier you can remove the air cleaner and the air cleaner housing then unscrew the sensor on top of the tranny you can poor it in from the top. You will need to then unscrew the fill hole (Top right bolt) Pour the lube in to the hole where you had taken out the sensor until it pours out of the fill hole. Sounds like more work but by doing this you will avoid making a mess trying to fit the squeeze bottle into the tiny hole. Hope this makes Sense????
SOURCE: hyundai coupe 1.6 late 98 model 61k miles.
The best thing you can do for now is go for an engine flush and have the mechanics clean your jets. have the timing set by the manufacturer aswell.
Other than that you must enjoy this great car
SOURCE: gear box dip stick location- hyundai lantra automatic
try the left side of the engine... gear oils smell are diffent from the engine oil and the viscosity... gear oils are thicker... u wont go wrong on this...
?€¢
The throttle actuator motor
?€¢
The throttle position (TP) sensor 1 and 2
The throttle body functions are similar to a conventional throttle body with the following exceptions:
?€¢
An electric motor opens and closes the throttle valve.
?€¢
The throttle blade is spring loaded in both directions and the default position is slightly open.
?€¢
There are 2 individual TP sensors within the throttle body assembly.
Oh yea it has two TPS - throttle position sensors ! An you have to replace the whole assembly !
119 views
Usually answered in minutes!
×