SOURCE: mitsubishi triton 1988 wont start
Check the compression using a compression tester you can buy at a parts store. The compression has to be fairly high in all cylinders to start up the engine. If not you may have bad rings . Check plugs and wires too.
SOURCE: need pics and tips to change timing belts and
purchase either a Haynes or Merck manual. Great for future reference if you intend to keep the vehicle for awhile.
SOURCE: i need to know which
the color (black) represents negative or ground. if you know how to use a multimeter, that will tell you if it is ground or current. Thanks
SOURCE: Hi, im searching for the stereo wiring chart for
This is all I could find. Hope it helps.
WIRE COLOR POLARITY LOCATION
Battery RED/BLACK (+) RADIO HARNESS
Accesory BLUE (+) RADIO HARNESS
Ground BLACK (-) RADIO HARNESS
Illumination GREEN/WHITE (+) RADIO HARNESS
Power Antenna YELLOW (+) RADIO HARNESS
LF Speaker (+) WHITE/BLUE
LF Speaker (-) BLACK/BLUE
RF Speaker (+) WHITE/RED
RF Speaker (-) BLACK/RED
LR Speaker (+) YELLOW/BLUE
LR Speaker (-) GRAY/BLUE
RR Speaker (+) YELLOW/RED
RR Speaker (-) GRAY/RED
SOURCE: I need to know what the six wires that are on one
That connector is for the lumbar support in the seat. The wires are as follows:
Black - Ground, ends at left side under the dash.
Red and Black - Power to circuit fromk fusible link
Yellow and Green - Lumbar support, Push out
Red and Yellow - Lumbar support, Release in
Yellow and Blue - Side lumbar support, Spread out
Yellow, Should be Yellow and White- Side lumbar support, Close in
Hope this helps. Good Luck!
43 views
Usually answered in minutes!
×