How to replace serpentine belt?

type your question into google hundred of answers


2007 DODGE Grand Caravan Serpentine Belt Diagram for V6 3 8 Liter Engine...

Hi , could you supply the correct engine code and vin number ?
For the engine code (EKG) the firing order is 1-6-5-4-3-2
For the engine code (EGH) the firing order is 1-2-3-4-5-6

i need to see a diagram for a 2010 dodge grand caravan with a 3.3 liter It has air condtion

Removing and changing the water pump on a 2000 Grand Caravan should only be done if your van has a 3.3 liter or 3.8 liter V6 engine. On any other engine types, including four-cylinder engines, you must remove the timing belt from the engine to access the water pump, which is a dangerous task that can mess up the engine if attempted by an amateur.
The procedure is as follows:------------- The water pump is responsible for sending the engine coolant to the engine.First of all remove the serpentine belt then remove the plastic cove on the passenger side behind the wheel. You will have to remove the pulley. Once the pulley is removed unbolt the water pump and remove it. Clean the surfaces and install new pump. Draining the coolant and replacing it is advisable.Drain the engine coolant, twisting and removing the drain plug at the bottom of the radiator
-------------------Thats it.

OK, do you have a specific question? You'll need to jack up the front right tire and remove it. Pull the wheel well cover off to expose the belt. Use a vice-grip in the tensioner pulley (look for a 1.2 in square on the end of the pulley) to remove tension. Install as the sticker under the hood shows.

It's posted inside the hood. Lift hood, look on passenger side.

You can check out the autozone.com website and register the vehicle. It's free and you will have access to an online repair manual for the vehicle. The steps for changing the belt and the routing diagram should be available there. Hope this helped and best wishes.

Removal & Installation

3.0L Engine

1. Before servicing the vehicle, refer to the Precautions Section.
2. Remove or disconnect the following:
   
   Negative battery cable Wiper module Accessory drive belt Alternator mounting bolts Alternator harness connectors Alternator
   

To install:

1. Install or connect the following:
   
   Alternator Alternator harness connectors Alternator mounting bolts. Tighten the bolts to 40 ft. lbs. (54 Nm). Accessory drive belt Wiper module Negative battery cable
   
hope this helps let me know if you need more. dc

check the ground cable all the way from the battery to engine im betting its loose or not getting a good connection somewhere

What engine do you have? The 3.3 and 3.8 engines have a single serpentine belt, and a belt tensioner, so no adjustment is needed. Did you replace the tensioner, and want to know how much to torque it? countrycurt0