If you mean Idle Air Control, it's on the throttle body below the throttle position sensor. I think it's a deep, 28mm socket that fits over it, or you can use a big adjustable pliers or wrench. Read the instructions on the new one. Don't loose the pintle! Don't turn the ignition on with the IAC hooked up but not in place. The pintle will go flying out.
SOURCE: tail lights fora 1986 Fiero
rear of the car is totally different, if you want to do the gt conversion you will need to exchange the whole rear clip.
gt light are wider,cant use just the lens or cover.check for parts at vegas fiero club
SOURCE: need to locate the ignition control module in my 1985 fiero gt
Take off the distributor cap, it is held on by two screws and has three plugs, 1 to the pick up coil, one to the computer, and one to the ignition coil.
SOURCE: need a wiring diagram for distributor for a 1988 pontiac fiero gt with a 2.8 v6
There are two plugs which are plugged into the distributor one is a two wire and one is a four wire. the two wire has a pink wire on terminal A and a white wire on terminal B these two wires go to the remote coil black plug The four wire has a black wire with a red trace on terminal A A tan with black trace on terminal B A purple with white trace on terminal C A white wire on terminal D
SOURCE: water pump housing
it connect to the block. I have some good news that is one of the cheapest water pumps on the planet and easy to replace
http://www.racepages.com/parts/water_pump/pontiac/fiero.html
Please rank
221 views
Usually answered in minutes!
×