Hi, Easy way to get over this is run a cable from working fog light to none working fog light this should then work. Only other way must be the left fog light is not earthed properly run earth wire to the vehicles body. Please give feedback at [email protected] Thanks, Malcolm Campbell.
SOURCE: Fog light bulb replacement
This bulb can be replaced without removing the washer fluid reservoir. There are 3 screws that go through the bottom edge of the bumper cover into the right inner fender guard. Remove these screws and pull the inner fender down to gain access to the back side of the fog lamp and remove the bulb.
Nissan Scope Technician- 10+ years experience in Nissan dealership.
SOURCE: BMW Z3 SPORTS CAR 1998
its the dreaded seat rock syndrome, plenty of fixes on the forums, basically you have to replace spacers in set drive mechanism. I did with the help of a friend after ordring bushes and it was quite easy.
SOURCE: Replacing 2000 toyota avalon fog light bulb
o easy enough just jack frontcar up use jackstand for safety now loo up under the bumper where fog lights sit depending on style fog light u might need to pull the whole assembly out or just twist the bulb not a hard task once u see it from underneath it is pretty easy
SOURCE: 2001 subaru outback headlight not working
chapmnfarm: your head lights use a "2" fuse system.
one for the left and one for the right.
The fuse box you are looking for is under the hood on the passenger's side. It is a black box roughly 8 inches long and 4-5 inches wide. When you remove the cover, you will see fuses and relays. What you are looking for is the section in the box which has a cluster of 7 fuses. 3 in one row and 4 in the other. On the outer parameter are two relays. The fuses you are interested in are located in the row of 4 fuses, with the two closest to the "L" shaped part of the box. Both of those should be 15 amp fuses.
The fuse below those should be a 20 amp which is the lighting switch and the one below it is a 15 amp which is for the interior lights and the clock.
Check your harness grounds in the engine compartment near the area you have the problem. There are ground wires which come out of the harness on both sides of the core support. The wires are black in color and have "EYES" crimped onto the ends of the wires. Both of them will probably be located about 4-6 inches below the upper tie bar on each side of the radiator. Odds are that the eyes will be large enough to pass a 6mm bolt through.
I hope what I have given you will resolve your problem. Lem me know,,good luck>>>>>>>>>>>>>>>
SOURCE: 02 pathfinder, headlight still won't work
Unlikely to be the column swithch . try high and low? Check for power at the plug.
235 views
Usually answered in minutes!
Ok! So I believe it's the plug, no I'm sure it's the plug. It looks worn out and looks like previous owner tried to fix it HIMSELF. Question is how can I replace the plug with a new one? I want to aleast try to do it myself, any suggestions?
×