How to replace timing belt on 1994 toyota corolla?
SOURCE: 1994 toyota corolla alternator belt replacement
loosen the bolt that is holding the adjuster of the alternator. loosen the belt by pulling it and the alternator would slide in. remove and replace the belt.
do the reverse on installation.
remember to tighten all bolts of the adjuster and alternator after tightening the belt.
tnx 4 using fixya,
drcool
SOURCE: 1994 Toyota Corolla - Valve COver Gasket Replacement
You need an aftermarket serviice manual from Haynes or Chilton.
They will have that kind of info.
I know of no car (I don't know them all) where that is needed and depending on the cover material (sheet steel or cast), could lead to warping and new leaks.
I always use a thin film of silicone whether it is specified or not and there are torque specs for ALL valve covers I have ever seen.
SOURCE: toyota corolla 1994
theres no cable in toyota corolla 1994 check the speed sensor or replace speedometer have same problem with my 1993 toyota corolla
SOURCE: Replaciing serpentine belt on 2006 Toyota Corolla
You'll have to remove the engine cover under the bottom so you can position the new belt on the pulleys properly. Get a wrench or tensioner tool and turn the tensioner clockwise to relax the drive belt. Don't apply excessive force.
It's hard to draw a picture with words, but looking at the engine from the passenger side of the car, there are basically two top pulleys, two middle, and two bottom. The drive belt goes around the outside of the two top and two bottom, and on the inside of the two middle.
302 views
Usually answered in minutes!
Your best bet is go buy the manual for this vehicle. It makes things real simple then google
×