Location of the headlight delay module
SOURCE: NEED TO CHANGE BODY MODULE IN 1999 JEEP CHEROKEE.
The Cherokee doesn't have a body control module however the Grand Cherokee does. It is behind the kneeblocker trim panel under the steering column directly in front of the drivers left knee.
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: 2000 jeep cherokee sport 4.0
I believe that year had distributorless ignition, instead it uses a form of coil on plug ignition system.
If you open the hood, stand at the front of the vehicle. Look to the left side of the engine, around the bottom of the valve cover (The valve cover is where the oil fill cap is. The oil fill cap is on top of the valve cover), at the bottom of the valve cover on the left side you will see a series of humps. Those series of humps is the coil packs, the coil packs are all in one long piece held down by three or four bolts.
Take out those bolts, gently pry up at the ends of the coil pack and it will eventually come out. You'll see on the bottom side the spark plug boots are attached to the coil pack. After you get the ignition coil pack off, you will see the spark plugs under where the coil pack came from, the boots on the coil pack sit directly on the spark plugs.
SOURCE: where is the speed sensor located on a 2000 jeep
Since you have the die hard, can not kill 4.0, I believe this mated with the 42RE transmission. My understanding It use's a single sensor (located on the overdrive gear case, over the park gear).The 42RE transmissions use a single sensor (located on the overdrive gear case, over the park gear). The 42RE transmissions use a single sensor (located on the overdrive gear case, over the park gear).
SOURCE: Where is the oil pressure sending unit located on
Removal & Installation
Oil pressure sending unit
To install:
1,726 views
Usually answered in minutes!
×