Fwd
To check transmission fluid in a 2011 lexus rx 350 fwd there is no dipstick, but the transmission is not sealed as the dealer will tell you, thats a gimic for you to bring youre car to a dealership!
simply remove the drain plug from the transmission on the main bottom, the fluid will not come out, there's another fluid retaining plug above that!
next the fluid add hole is on the side of the transmission behind the driver side wheel towards top of transmission!
you simply add fluid whether you pump it in or snake a rubber hose off of a funnel, when the fluid is full it will come by the bypass plug and leak out the drain hole, at this point that's the correct amount of fluid!
simply re install the drain plug and the fluid add plug and you're done!
cost me $100 at a transmission shop to find this out yesterday
SOURCE: Lexus RX350 Reset Maintenance required light
PRESS AND HOLD IN THE TRIPOMETER RESET BUTTON. WITH IT IN, TURN THE KEY TO THE ON POSITION WITHOUT STARTING THE ENGINE. THE DISPLAY WILL COUNT DOWN IN HASH MARKS FROM 6 TO 0. AFTER IT REACHES 0 RELEASE THE TRIPOMETER RESET, TURN THE KEY TO THE OFF POSITION. ONCE YOU RESTART THE LIGHT SHOULD BE OFF.
SOURCE: how do you check the transmission fluid level on
you dont. you will have to go to the dealership. It is what is now called a sealed transmission and usually lasts the life of the car
SOURCE: I bought a used lexus RX350 2008 and I can't find
it is usually given to the owner and in the glove compartment or in the kit area for the jack if you still can not find it Lexus wheel locks have a unique shank on the base and can only be replaced at the dealer so ask the dealer
SOURCE: Remove Nav disc for Lexus RX 350 2010
If you have a June 2009 model , may not be the latest version.Confirm with parts dept if they are compatible discs for the 2007 . A NAV update just came out this fall. The 2007 plays from the disc , in the back of the car . You might be able to swap your June disc into the 2007 and buy the latest version for your 2010, either in disc or one time USB down load.
SOURCE: 2007 lexus rx350 ,vsc light on and check engine light is flashing
First check and make sure your gas cap is tight, if this does not resolve the problem read below.
A vacuum hose has become disconnected, more than likely due to having your air filter replaced. The VSC and Check engine light typically don't come on until after 150-200 miles after the vacuum hose was pulled out.
The fix: on the right-hand-side of the engine compartment behind the big plastic housing that holds the air filter you will find a black rubber hose that is not connected to anything. Squeeze the finger clamp on the hose and slide the hose back onto the half inch nipple on the back of the air filter's plastic housing.
In order for the VSC and Check engine light to be turned off, you will need to open the fuse box, right-side of the engine compartment, and pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The fuse location is marked on the lid of the fuse box, also I believe the EFI fuse is the only 20 amp fuse
. This will help. Thanks, please keep updated. please do rate
the solution positively .thank you for using fixya
5,197 views
Usually answered in minutes!
×