On some jeep models unhooking the battery will set off the alarm . try cycling the drivers door lock with the key to reset . if alarm is on will cause no start
The starting fluid things results are what is leading me here , I'm calling it an ignition problem (read:no spark).
The issue you have had with the ignition module a couple a months ago leads me back there as well.
When the module was replaced , was the white heat transfer grease spread liberally on the heat sync?
Failure to do this will cause the module to overheat easily enough.
The flashing lights now, That's a stumper. Is the emergency warning light switch turned on?
I'd assume the alarm could be disabling the ign. , But you say you are getting spark. The alarm would explain the lights.
Pull the distributor cap and turn the engine over... is the rotor turning? (checking for a broken timing belt)
×
298 views
Usually answered in minutes!
He has spark all the time-- as for the transfer grease I,m not sure but will check-- he said the parking lights are flashing like when the alarm is going off, could this problem with the starting be related the the security system and can it be disabbled? Thanks Jeff
He has to leave for college so we will try tomorrow--I will post tomorrow thanks for the help
×