SOURCE: Crankshaft position sensor location - 1991 Dodge Dakota 5.2L
it is on the passenger side on the back off the motor.there are two allen head bolts or 13mm.it goes into the transmission and normally has rubber at the opening.you should be able to gets this from the top follow middle of valve cover on pass. side the go strait back toward the fire wall.please rate this answer.
SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE
Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?
SOURCE: 04 Dodge SRT 4 crankshaft sensor
The Crankshaft Position Sensor is located directly next to the starter.
Reverse Order to install except note that:
Use a twisting motion when installing the sensor.
Install and tighten the crankshaft position sensor bolt and tighten to 9 N·m (80 ±15 in. lbs.).
SOURCE: location of crank sensor
It is in the top of the transmission bellhousing near where the engine meets the transmission.
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
2,701 views
Usually answered in minutes!
×