1990 Jaguar XJ6 Logo

Related Topics:

Posted on Apr 28, 2012

How do i get the codes to diagnose a 1990 xj6 Jaguar Sovereign

How do i diagnose the problem on my xj6 1990 Jaguar

4 Related Answers

Anonymous

  • 1 Answer
  • Posted on Aug 09, 2009

SOURCE: where is the fuel pump relay on a 1990 Jaguar

The fuel pump relay on my 1990 is located on the passenger side under the dash. You have to remove the lower interior panel to expose a number of relays there will be a color guide that tells you which relay is the one for fuel.

Ad

Anonymous

  • 1 Answer
  • Posted on Sep 15, 2009

SOURCE: 92 Jaguar XJ6 stalls after breaking

did you figure out what the problem was?

reichweinj

Joseph Reichwein

  • 71 Answers
  • Posted on Nov 10, 2009

SOURCE: Jaguar xj6 4.0 1990. showing fault code fuel 14,

2 airflow sensor out of operating range 3 coolant temp sensor out of operating range 4 oxy sensor indicates full rich 5 throttle potentiometer/airflow sensor... (low throttle pot signal with high airflow sensor signal) 6 throttle pot/airflow sensor...... (high throttle pot signal with low airflow sensor signal) 7 throttle pot...idle fuel adjustment failure(idle speed??) 8 intake air temp sensor...open or shorted circuit to sensor 11 Throttle pot at idle: Throttle pot idle trim out of normal range 12 Airflow meter: MAF signal out of range 14 Coolant thermistor: Resistance out of range or static during engine warm up 16 Air thermistor: Resistance out of range 17 Throttle pot: Out of range 18 Throttle pot/Airflow: Low throttle pot signal at high airflow 19 Throttle pot/Airflow: High throttle pot signal at low airflow 22 Fuel pump drive: ECU output to fuel pump relay 23 Fuel supply: Engine running too rich 24 Ignition Drive: ECU output to ignition Amp 26 Air leak: Engine running too lean 29 ECU self check 33 Injector Drive: ECU output to injectors 34 Injector: Looks for Injector dribble 37 EGR Drive: ECU output to EGR switching valve 39 EGR check sensor: EGR not working (normally pipe blocked) 44 Lambda (O2) sensor: Poor mixture control rich or weak (or misfire) 46 Idle speed Control valve: ECU output to Coil AB 47 Idle speed Control valve: ECU output to Coil CD 48 Idle Speed Control Valve: Stepper motor grossly out of position 66 Air pump: ECU output to air pump relay 68 Road speed sensor: Seen speed < 5km/h at high engine airflow 69 Drive/Neutral switch: Seen cranking in "D" or high airflow in "N" 89 Purge Valve drive: ECU output to purge valve
this is all I could find

Anonymous

  • 24 Answers
  • Posted on Mar 30, 2010

SOURCE: jaguar xj6 jaguar gold 1993 dashboard warning lights

Sounds like it could be the traction control light?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Ignition key will not turn in cylinder .. it is frozen have tried jiggling lubricating ,shifting ,turning wheel etc ... no results

the tibs ignition key barrel has worn out and/or key you need to get a new barrel and key or a kit that you can reassemble yourself so the origional key will fit if its not worn out. go to your jag dealer these parts may not be availiable. easily try jaguar heritage website
0helpful
1answer

1990 Jaguar Sovereign XJ6 Fuse 1 Fail

Well I guess you know you have a shorted wiring harness in the car, so you need to find that short.
0helpful
1answer

Location of fuelpump on a 1990jaguar xj6 sovereign

Fortunatly your pump is external, attached to the frame near the rear drivers side wheel.
1helpful
2answers

Check engine light stays on- 1990 jaguar sovereign xj6

With the car in key position 2, the position right before you turn it to start, hit the VCM button on the right trip meter, you will get a code.
0helpful
1answer

I have a 1990 Jaguar Sovereign, 98,000 miles. The problem I'm having is the engine starts and runs, but it lopes at idle and runs rough, seems to be running too rich. I was getting fault codes 44, 37,...

I would change the air filter and clean the fine mesh covering the air flow control unit.
Make sure the connections are good as the sensor screen is tied to the O2 sensor. A new O2 sensor and dirty screen would give you poor fuel burning as the air fuel mix would be bad, and the O2 sensor would read the need for more fuel.......poor economy and running rough as it would not be clean burning.
6helpful
2answers

Where is the fuel pump relay on a 1990 Jaguar sovereign, also is there a way to get into the trunk with out a key and the electric lock is not working. (there is no crawl space behind back seat)

The fuel pump relay on my 1990 is located on the passenger side under the dash. You have to remove the lower interior panel to expose a number of relays there will be a color guide that tells you which relay is the one for fuel.
1helpful
1answer

Like to turn off check engine light on my 1990 xj sovereign

disconnect negative battery terminal few minutes
0helpful
1answer

Can not access my 1990 Jaguar soveriegn due to flat battery

the key should open the door without any batt power central locking is batt , the key should open both front doors!!owered so it should not be a problem !
Not finding what you are looking for?

257 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...