Turn signals do not work
It is caused by either a bad multifunction (turn signal) switch or a bad combination flasher. With this particular vehicle, the flasher is an integral part of the multifunction switch. So, it can only be repaired by replacing the multifunction switch for either case.
SOURCE: I have a 2007 Chrysler Pacifica Touring. The front
there are separate relays and fuses under the hood in a black box check the fuses first and then the relay for the front turn signals and flashers
SOURCE: 1997 Chrysler Sebring jxi
Are you trying to replace one of the turn/hazard signal bulbs? If so, which one. The backside of the bulb will turn about a quarter turn and come out the back side of the housing then you can change the bulb out as usual.
SOURCE: milage odometer on 1997 Chrysler Sebring doesn't work
i got a better way you to fix it http://members.cox.net/dpeters30/97_sebring_dash.htm it free if you know how to solder. It works I did it this june and it still works
SOURCE: turn signals work intermittenly
I have a 99 Chrysler 300 M, my turn signals aren't working. Tried the fuse, was told there is a relay somewhere that controls the turn signals. Please help
SOURCE: i need to find where to replace the flasher on my
Chrysler Cirrus/Stratus/Sebring/Avenger/Breeze 1995-1998
Flashers - Replacement
Flashers are located
either on the bottom of the fuse block or on a module under the
dashboard. They are replaced by simply pulling them straight out. Note
that the prongs are arranged in such a way that the flasher must be
properly oriented before attempting to install it. Turn the flasher
until the orientation of the prongs is correct and simply push it
firmly in until the prongs are fully engaged.
More details and wiring diagrams can find in autozone.com (free register).
I hope helps with this (remember rated this help) Good luck.
700 views
Usually answered in minutes!
×