Want to put old style switch in the floor need wire diagram
SOURCE: firing order diagram on a 1987 mazda B2600
To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.
If a distributor is not keyed for installation with only one orientation, it could have been removed previously and rewired. The resultant wiring would hold the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes in your book to reflect how your engine is wired.
Fig. Fig. 1: 2.2L Engine Engine Firing Order: 1-3-4-2 Distributor Rotation: Clockwise
Fig. Fig. 2: 2.6L Engine Engine Firing Order: 1-3-4-2 Distributor Rotation: Clockwise
SOURCE: spark plug wire diagram for 88 mazda b2600 help
I've 2 diagrams for you. In both, the distributor rotation is clockwise.
2.2L
2.6L
SOURCE: hi in need of a wiring diagram fuse box Mazda bongo
look here: http://www.bongoforum.co.uk/forum/Blah.pl?
SOURCE: i wanna wiring diagram
buy a haynes workshop manual ,not enough upload capacity on this site to put anything like this on here
SOURCE: i need to set up the camshaft timing marks on a 1994 mazda b2600
its not just the camshaft timing marks you set up, you also have to have the crankshaft timing mark set right to or you may damage your engine
check the internet for the right timing procedure for you model car ok
Fig. Fig. 1: 2.2L Engine Engine Firing Order: 1-3-4-2 Distributor Rotation: Clockwise
Fig. Fig. 2: 2.6L Engine Engine Firing Order: 1-3-4-2 Distributor Rotation: Clockwise
246 views
Usually answered in minutes!
the switch in wheel is bad an only works on High beam .And the switch new is over two hundred ,Ive did this before on vechical,s before but need a wiring diagram for the three wires going to dimmer the main feed and the high an the low wires
×