Prices for bumper, headlights, signals for a 1990 bmw 525i

oddly enough, check the wheel speed sensors. there are 4. the fronts are the same the backs are the same but the fronts are not the same as the back.

STOP what you are doing before you damage something!! Whatever you are trying to remove is not the water pump. Neither the sparkplugs nor the "timing belt" cover needs to come off. Remove the fan belt. Remove the fan (the nut is LH thread- means it turns left to tighten and right to loosen). You will need a large wrench (32mm) availible at sears.The water pump is directly behind the fan and is held in by 4 10mm bolts.

There's trapped air in the cooling system.

• You need to remove the bleeder screw on top of the radiator when adding water to the expansion tank.
• With the engine running, pour water into the expansion tank till you see air go out through the bleeder screw's hole.
• Just keep adding water until no more air bubbles come out then just put the screw back in place.
• Then fill the expansion tank to it's normal level/line.

power distribution box problem ,take ti out look underneath and no doubt the links corroded out ,well for the dipped light anyway the stop light is no doubt the switch faulty so replace the stop light switch .

Have you found the fuse box, under the bonnet on LHS of vehicle?
In the lid of the fuse box it will outline which fuse controls the function.

Try replacing the thermostat. It is supposed to open when the water temp reaches a certain point usually around 180 degrees. It might be stuck in the closed position.

No there are just the front bumper ones.

You will need fuel line block off clamp

Check the wiring in the lights it may be poor construction or mis care that has madr a wire become looseand only rarely turn on