Get a 2nd opinion...There are a lot of bad people in the world...If it's low on oil just get them to add oil...But tow it to another garage...It won't cost much but it might not be the motor...Then you know if they was telling you the truth... Sometimes when you tell them you towing it to another shop they will say that they they have found the real problem...Get a 2nd opinion
No
get a good working engine from the wreckers/junk yard because a new engine will go the same way of the old engine if you are to careless to check the oil
SOURCE: Car will not start when cold on first try
its the passlock system. The passlock wire is tiny and fragile, and gets disrupted causing your car to think you are trying to steal it everytime you put your key in.
now you can search for this video on youtube, this is where i learned and ever since i did this i have had NO problem with my car starting for the past 5 months.
you need wire nuts, wire cutters, electrical tape, n socket wrench to take apart steering column
first, go to your fuses, find the airbag fuse and remove it just incase you snip the wrong wire. what you do is look below your steering wheel and take your steering column apart. there are a serious of wires electrical taped together that are plugged in. you peel all the electrical tape back exposing the wires, and you find the WHITE wire. its all white, no other color. This wire is for your Passlock system.... this is the wire that got faulty and is causing the car not to start. now what you do from here is kinda tricky, not too bad though.
Seclude the white wire from the rest, so that you are ready to make your cut. Now, what you do is start your car, leave it running, and while its running you cut the white wire in half. then after cutting the wire, turn your car off, and then turn it back on. it should start right up. Then just put wire nuts on the two ends, and electrical tape them back together
The point of doing this is, one is disables the passlock system completely, and two the reason why you do this while the car is running is because snipping the wire with the car running makes the car think that it got into an accident or something, and puts the BCM/car into a "Fail-safe" mode, making it start every single time no matter what.
i thought this sounded insane at first, but after searching for a couple of hours its the only answer that made sense. and now i am the happiest camper in the world as far as it starting
SOURCE: starting problem for 03 saturn ion when engine is warm
replace the ign switch. the key has nothing to do with it.
SOURCE: 2003 Saturn Ion 3 with warning messages coolant & power steering
You need to replace your ignition switch. If it has already been replaced then you will prob. need a BCM.
SOURCE: 2006 saturn ion door locks and trunk pop wont work....
The remote won't ework because the problem is in the vehicle. Just for test purposes and possible remedy. Remove and clean the negative battery cable. Ensure a clean , tight connection. Then find the body ground. Yhis ground is locted usually at the top rear of the engine. .I's a snall stainless steel strap bolted to the engine and fire wall, This must olsobe clean with a good contack. Might as well clean the + cable and connection on the battery while you are there. Good luck and keep me posted olease. Good Luck, Ned_
Testimonial: "Thank you for your prompt response I will try that first thing in the morning and let you know!"
SOURCE: 2003 Saturn Ion will not start. Security lock is on.
The fix for this problem is well known, so is the cause. GM needs to step up in my opinion. You can fix it yourself if you're willing
http://moontaj.com/passlock
197 views
Usually answered in minutes!
×