I need to know the torque settings for 850cc reliant robin

Help in the link. I like to use a broader approach. Google

year nissan model A14 mains and big end torque settings

https://www.google.com/search?q=Torque+settings+for+nissan+A14+mains+and+big+end+bearings

..

Question edited for clarity and order, year make model cc and first in the question.
Question moved to model category.

Page 6

https://www.newtonnet.co.uk/coupe/GK-HMA-WorkshopManual/PDF/EM.pdf

More here

https://www.google.com/search?q=2008+Hyundai+Tucson+G4GC.+Torque+settings+main+bearings+and+big+end+bearings

..

Here are the torque settings for a Ford Fiesta 1.4 2010 for the main bearings, head bolts, and big ends:
Main bearings

• Main bearing caps: 1st stage - 7 Nm, 2nd stage - 16 Nm
• Main bearing bolts: 45 Nm + 90°

Head bolts

• Cylinders 1-3: 2nd stage - 30 Nm + 90°, 3rd stage - 80 Nm + 180°
• Cylinder 4: 2nd stage - 25 Nm + 90°, 3rd stage - 60 Nm + 180°

Big ends

• Connecting rod cap nuts: 1st stage - 22 Nm, 2nd stage - 40 Nm + 90°

Please note that these are just the general torque settings. The exact torque settings may vary depending on the specific engine and vehicle. It is always best to consult your vehicle's service manual for the correct torque settings.
Here are some additional tips for tightening the torque settings:

• Use a torque wrench to ensure that the bolts are tightened to the correct torque.
• Tighten the bolts in a star pattern, working your way from the center out.
• Do not overtighten the bolts, as this can damage the engine.

https://www.hyundaiaftermarket.org/forum/engine-intake-exhaust-11/hundai-i10-big-end-main-bearing-torque-specs-80245 https://www.hyundaiaftermarket.org/forum/engine-intake-exhaust-11/hundai-i10-big-end-main-bearing-torque-specs-80245

Download this manual. It should have all the torques you are asking for.

http://www.championbrands.com/aera-torquespecs.pdf

Toyota Yaris Main and Big end Torque settings:
Tighten the main and big end bolts in sequential order and in two steps.
Main bearings. Stage 1.
22 ft lbs.
Stage 2.
44 ft lbs

Big end bearings.
Stage 1.
11 ft lbs.
Then Rotate bolt head a further by 90 degrees

Head bolt torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10

Flywheel spec:
65 ft lbs

Morning please advise on Torque settings for big end bearings on a ascent 1.3 X's please.

if you have a rebuild kit. the specs are listed in the instructions.. if not call the parts store with engine info and they can tell you...

V6 colt bakkie big ends bearing torque settings

Mains Stage 1 83nm
Mains Stage 2 167nm

Big ends Stage 1 29nm
Big ends Stage 2 45 - 60 degrees

Hope this helps