I need a diagram on how to replace the fron turn signal bulb on a 2006 Cadillac SRX. Or detailed instructions. Replacing front turn signal bulb on 2004 Cad SRX
Wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
To Start I\'ve had to replace three 0n a 2005 (twice on pas. side, once on drivers side). It\'s not especially easy but... first: remove the tire, second: remove the plastic inner fender wells (the fasteners are a 2 piece plug/screw type fastener(inner and outter plug that is pushed in the hole that holds the inner fender wells in place. you can use a narrow slotted screw driver to separate these...then pull it out of the hole...DON\'T just pull it out without separating or it will not hold in place as well.With this out of your way you will need #15 torx screwdrivers (you are gonna need two different lengths (short & long) there are six screws that hold the outter cover on, with this open THERE are your bulb sockets just twist counter-clockwise and pull ut the socket and change your bulb (another thing...if you use after market and not O.E.M there will be tabs on the side of the base of bulbs that I had to use a file on so it would fit in bulb socket). I can also tell you the drivers side is harder than passenger side. Bottom line it is a pain but it\'s cheaper than your dealership charging you three hours shop labor to replace a $4.00 bulb. Good luck and while you are doing it just keep reminding yourself "COST OF SHOP LABOR"
For a permanent repair, get the updated light sockets from the dealership.
Check out my pix at http://srxturnsignals.shutterfly.com/
7,636 views
Usually answered in minutes!
ya Cadillac wants $225 to replace bulb! my service advisor said it may be the socket that neeeds to be replaced also?!?
replacing front turn signal bulb on 2006 cadillac srx
what are wheel bearings? I was told they need replacement for my 2004 SRX
Replacing amber lens on mirror housing
where is the airbag control sensor on 2004 cadillac srx
I need to get my starter replaced on my car but need to explain where it is first :)
what is firing order on 2004 Cadillac SRX
how to replace knock sensor 2004 srx
where is knock sensor located
how to remove front signal light bulb 2011 srx
engine light come on
starter
Hi I have 2006 Cadillac srx when I first step on the gas from stand still the car hesitates really bad and then goes it feels like reving it up in neutral and just throwing it in drive
How do you reset the engine lite on a 2006 cadillac srx
2007 cadillac srx hesitation or slipping while accelerating
Need to remove and replace the license plate nuts from the rear lift gate and install new ones.
I need to disconnect the battery terminals for cleaning on my 2011 Cadillac SRX. Does that affect the memory that holds all the personalization settings I have made?
stops before it drops to shut
stops short from where it drops to completely shut
need to replace
wOULD LIKE TO KNOW WHERE THE ABOVE SENSOR IS LOCATED ON MY VEHICLE, HELP
the front drivers side heat is not working but the passenger side is
have a 2006 srx heat not working on drivers side but is on passenger side just changed engines
fuse box location
I have Blackberry Bold and a 2012 Cadillac SRX The device is paired fine, but when I turn on the car the steering wheel controls for the radio do not work unless I press the "make a call button" and then hang up the phone. Then I can change the radio stations. This just started happening a few days ago. Also, I cannot answer incoming calls, but can place outgoing calls just fine. What could be the problem?
locating firinf order
replace license plate bulbs
rear end noise
Cadillac srx rear end noise
It states that 2 different remotes are programmed
water pump replacement
want to pound out dent on a right front side panel on my srx
×