SOURCE: Range Rover 2006 brake fluid flushing (when?)
brake fluid should be changed every time you change the brake pad. Brake fluid is not the same as hydraulic fluid, which don't contain alcohol, which attract moisture and dirt.
with that say, I don't think too many people really change the brake fluid, not till the brake stop working.
SOURCE: how do i change drive belt on p38 range rover
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.
Not sure if this what you need for the "P38" but it is for the 1996 Range Rover.
I do not know if you still need this information, but I am going ahead and answering it anyway.
Click on the following Link. It has the several Serpentine Belt Diagrams, one of which matches your specific vehicle with your particular options (AC, Power Steering etc..).
Regarding HOW:
Standard Rule to Removal the Serpentine Belt:
1. Find the Tensioner(s). (See Diagrams on Link)
2. Rotate/Move the Tensioner away from contact with the belt and towards the area where the belt is not in contact with the Tensioner Pulley. The Tensioner is spring loaded, and is hard to rotate/move.
3. Remove the loosened belt off one of the other more easily accessed Pulleys.
Standard Rules for Installing the Serpentine Belt:
a. Pick a Pulley that is most easily accessed. This will usually be on top. This will be the last Pulley that the belt will go on.
b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right.
c. Using a Serpentine Belt Tensioner Tool or Wrench or Ratchet Tool: Rotate/Move the Tensioner Pulley/Arm "away" from Belt contact area on the Tensioner. This spring is pretty hard and with a new belt, it will be even harder to install. Rotate/Move this to as-close to the maximum allowed inorder to have enough slack in the belt to get it up and over the last pulley.
d. Using your other hand - Pull the Belt up and over the Last remaining Pulley.
e. Before releasing the pressure on the Tensioner, visually inspect the remainder Pulleys and the Belts' Positioning on them.
Let me know if this helped...
http://www.2carpros.com/car_repair_information/year/1996/make/land_rover/model/range_rover/1996_land_rover_range_rover_drive_belt_routing_diagram.htm
SOURCE: 2006 Range Rover Sport heater and A/C fan do not
Check all electrical conections. If they are good then it is probably the switch itself.
Testimonial: "I'll take a look at the switch. All connections seem fine."
SOURCE: On my 2006 range rover
have the engine light tested for free that will tell you the problem good luck
632 views
Usually answered in minutes!
×