Where is the radio fuse

You buy a harness from the the aftermarket radio shop that supplies you with the new radio.

RADIO - Buick Rendezvous CXL 2004

Automotive Electricians Portal https://portal-diagnostov.com > 2020/04/04 > radio-bu...

Apr 4, 2020 - RADIO - Buick Rendezvous CXL 2004 - SYSTEM WIRING DIAGRAMS Base Radio Wiring Diagram, with Rear Controls. Get Access all wiring diagrams car.

• 
  

  Buick Rendezvous CX 2004 - SYSTEM WIRING DIAGRAMS

  https://portal-diagnostov.com > 2020/04/04 > radio-bu...
  Apr 4, 2020 - RADIO - Buick Rendezvous CX 2004 - SYSTEM WIRING DIAGRAMS Base Radio Wiring Diagram, with Rear Controls. Get Access all wiring diagrams car.

2004 Buick Rendezvous Radio Wiring Guide

MODIFIEDLIFE https://www.modifiedlife.com > 2004-buick-rendezvo...
Our 2004 Buick Rendezvous radio wiring diagram shows you all the 2004 Buick Rendezvous radio wire colors and what they do. Use our 2004 Buick Rendezvous stereo ...

Buick (2004-2006) Century, Regal, Rendezvous Head Unit ...

PinoutGuide.com https://pinoutguide.com > ... > Buick pinouts
Jan 28, 2022 - OEM radio stereo harness pin assignment. Hardware connector pinouts and cables circuits ...

BUICK RENDEZVOUS 2002-2005 VEHICLE WIRING

JustAnswer https://f01.justanswer.com > BUICK+RENDEZ... PDF WIRING INFORMATION: 2002 Buick Rendezvous. WIRE. WIRE COLOR. WIRE LOCATION. 12V CONSTANT. ORANGE. Ignition Harness. STARTER. YELLOW. Ignition Harness.
5 pages

Wiring is in the link. Match with the new one wiring schematic.

https://www.google.com/search?q=toyota+tacoma+stereo+wiring+diagram

Other help

https://www.google.com/search?q=toyota+tacoma+radio+replacement

...

Dave, although you didn't say, i'm assuming you want to put a new radio in your car? If so, you can go into Best Buy and maybe other electronics suppliers and buy a wiring harness for your car. Your original car radio had a plug that allowed it to be easily plugged into the cars wiring harness. When you get a new car radio you can then buy a "plug" for your car that you wire to your new radio basically matching the color of the wires on your radio, to the wire of the same color on the plug you bought. Then you can easily plug your new radio into the cars harness. Hope that helps!

Hopefully you have not cut off the factory radio plug. Go to any store that sells car audio and buy the adapter harness for your car. The wire colors will then match up.

this is the wiring color code for the vehicle, so review the colors, and match them to the pin out of the new unit. The list is in th emiddle of the page.

1995 Buick LeSabre Stock Radio Wiring Diagram

Red is usually hot in 12 volt. Black in 110 volt. !2 volt tester is only about a buck at the dollar store. Turn ignition key to ON and test wire. The colors you test from present tape/radio should match the unit you are installing. If you still have doubts, buy a couple of 12v inline fuses and attach them to any wires you are playing with. They are cheap. Black is usually ground in 12v. Other colors usually relate to speakers.

go to best buy and get the sub harness the connects to your radio and plugs in to your car. then all you have to do is match the colors of the radio to hte colors of the sub harness

Jags are definitely a pure breed. The new radio most likely has writing on the wires that tell where they are to be connected to. I take that back. I just checked the wiring of an older model JVC unit and there or not listings. If your radios doesn't have writing just remember Orange(or yellow) is illumination, and it goes to the fuse block; red is power, going to the fuse block; the big black one is the ant.; the little one is the ground to the chassis. The others are speakers. Connect them to the colors they are closely resembling in your Jag. Connect the power and turn on your radio. You can reconnect the lines to the correct speaker by checking each speaker. hope this helps.

The auto and radio Dons have blessed us with a universal color code for all vehicles-that I've noted in all the systems that I've changed. If you're swapping out the stock Chrysler system you'll need to go to Walmart-or a store that sells audio equipment-to buy the Dodge/chrysler/jeep adapter. You connect it to the factory connect and splice the same colors to the radio. Most times the wire have the speaker it goes to written on it. If you have already cut the connector off and can't reconnect the wires, just match up the wires with the matching colors. Hope this helps.

Radio Constant 12V+ Wire: White/Green
Radio Switched 12V+ Wire: White/Red
Radio Ground Wire: Black
Radio Illumination Wire: n/a
Radio Dimmer Wire: Red/Black
Radio Antenna Trigger Wire: n/a
Radio Antenna Location: Rear Glass
Front Speakers Size and Location: 6 1/2′ Doors
Left Front Speaker Wire (+): Blue/Green
Left Front Speaker Wire (-): Gray/Black
Right Front Speaker Wire (+): Red/Green
Right Front Speaker Wire (-): Brown/Black
Rear Speakers Size and Location: 6′ x 9′ Rear Deck
Left Rear Speaker Wire (+): Blue/Yellow
Left Rear Speaker Wire (-): Gray/White
Right Rear Speaker Wire (+): Red/Yellow