How to remove a radio/cassette player from a Nissan Almera

SOURCE: Original radio

OK i just spent three hours with tha same problem really.
i removed casing around steering column done by removing 4 screws on the underside. the bottom half of the dash is also done up by a series of screws remove these also. Once bottom half of dash is removed there will be clips holding head unit in push these in and head unit should slide straight out. :)

SOURCE: '06 Nissan Murano factory radio/cd player removal steps

what holds the radio in place besides the 2 side screws in a 2006 nissan murano

SOURCE: nissan almera problems side light

heater blowing cold air only

Marvin

• 85242 Answers
• Posted on Mar 05, 2010

SOURCE: nissan almera ecu light

disconnect the battery negative cable for 5 minutes

SOURCE: Acura tl cd player doesn't work, radio and cassette player work

Try this as the stereo may need to be reset- If you have jumped or replaced the battery at anytime this will happen. You have to get the serial number off the radio by removing it or partially taking it out to see the numbers on it try not to remove any cords. With the stereo out (to make sure you get the right number off of it) call an Acura dealership with the number and they will give you the another number to enter into the stereo and directions on how to punch the numbers in. Make sure while you have the stereo out you write the serial number down and keep it in a safe place also the number that the Acura dealership gives you because if you sell the car or if it happens again its easily accessible. Good Luck!