My alarm is on but wont shut off

Question edited for clarity and toss in some CAPS.
Question moved to model category.

You need an alarm specialist. Anti-theft needs resetting.

https://www.google.com/search?q=mobile+auto+locksmith+near+me

..

Hogwash!! The traction control is incorporated with the ABS system and operates using the same sensors. It becomes active when one or more wheel speed sensors determine a slip in traction. If the vehicle is equipped with a traction button for turning off the system and it doesn't turn off, the button may be defective or possibly the control module.A scan test may be required on this module to determine the fault within the system. Your engine will not succumb to any damage. This mechanic needs some more training

Hi Rick:
Depending on the vehicle, there may be externally locking (warn) hubs on the front wheels. These have to be manually dis-engaged at the wheel hubs by rotating a fitting at the center of the hub. Otherwise, there should be a shift lever or switch inside the vehicle that will dis-engage the 4WD

The fact that the light comes on is a good indication that the electronics are working, the most common problem is a vacumn leak. This can be a damaged or cracked vacumn line, a bad check valve, or the dump switch on the brake pedal

It sounds like you will need to remove the trouble wheel and brakes to get it un stuck. If you have an enclosed cable leading to that side , if could have seized in the cable housing

It seems you have a throw out bearing at fault, got to dis connect the transmission for that one

NOTE: With the jeep cherokees. the Check Engine light if continuously driven with it on for more than 25 minutes whilst still traveling will engage the "PCM self protect" usually around the 27minute mark,and shut down the vehicle, and yes it takes 90 minutes to reset,

you might find that you will arrive ok, at your destination with this issue... pull up, and then it wont start again a few minutes later, this is the PCM Shutdown protection.....when the check engine light is on means the PCM is reset,found the error and why you can only run the car with the check engine light for about half an hour.

"You can however drive and turn the car off and coast in neutral and turn on the vehicle again to buy yourself more time with the "Check Engine time limit shutoff"

happened to me in mine, the error codes never showed up for the crankshaft position sensor
either...

i replaced the crankshaft position sensor under the transmission case, and it got rid of the issue this crank sensor is a common cause of the cherokees , it could no longer read the speed of the crankteeth. and can't get a reading the car is still running hence the shutdown, also you will find it also controls the PCM to engage your second fan on the radiator because it cant tell the vehicle is still running, and causes the PCM to get confused and wont let the rest of the engine function properly ie: coolant sensors, and Thermostat sensors, and you will find it overheats and needs to cool some times...which is why the PCM shutsdown the car.....try the crankshaft position sensor replacement under the transmission it's usually the cause of this on all cherokees "makes no difference if its a V8 or not by the way, same thing happens on 4.0 straight six engines also" .

bad thing trany going that the sign that it needs to be replace

Get in truck. Close doors. Turn key on. Push Odometer reset shaft until "Oil Life" message is displayed. Push and hold reset shaft until it "beeps" a few times. Oil change message is now gone!

dealer only