Replaced starter engine wont turn
If you want to defeat the system you need to make sure its the alarm system and not the ignition system,you are equipt with a pass lock system.Nothing in the alarm system change from the pellet type to the module of today,If you are trying to start the vehicle and the security light stays on.wait ten minutes with the key in the ON position,or until the security light goes off.Then turn the ignition to off before attempting to restart.
Testimonial: "Tank you................"
SOURCE: 2002 Pontiac Montana Thermostat replacement
check the coolant level fiirst...if that is low it wont give you any heat.....to change the thermostat you have to follow the top radiator hose to the engine.at the send of it you will see a clamp take it loose...then you will see the thermostat housing its held in place by 2 bolts . once you remove them you have the thermostat....make sure you clean all the old gasket material off both the housing and mount.also make sure you get a new gasket.
SOURCE: 2002 pontiac montana
You can download one here: Hopes this helps.
http://www.extendedgmwarranty.com/owners-manual/pontiac_owner_manuals.html
SOURCE: need to replace starter
should be 2 bolts 15mm and then 2 nuts on the starter 13mm and 8mm. this is a very easy starter to do. make sure you remover ground battery cable before doing this starter.
good luck,
michael
SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana
On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.
SOURCE: 2002 pontiac montana passanger pwr window
I beleive you need to change the Power Window Switches Module in the drivers side door panel, as these connections are interlinked within this module and it is usually the first part that fails. Especially that you already changed the switches & motor in the passenger door and it still does not work. Once you remove the dual switch module in the driver's side door, you will understand what I mean. Plus it is really easy to access. Good luck! I have the same model, Claude
699 views
Usually answered in minutes!
×