I changed oil filter and oil by my self. After approx. 1000km I have OIL -- flashing on my display before engine start. I checked the oil level and it is above max. I replaced the oil and the oil filter once more and again after approx. 1000 I have same flashing OIL -- and oil level is above max.
Check to see if gas is getting into the oil which would raise the level. This can happen from flooding, i.e. a leaky injector dumping too much gas or possibly gas blowby past the piston rings and ending up in crankcase. If gas is in the oil most likely an injector is bad. Smell the oil and check to see if it smells like gas and or check viscosity of oil.. thin oil
SOURCE: How do i change the oil in my Peugeot 207
the oil filter should be to the right of the head at the front it is in an aluminium housing with a black plastic top on it with a 27mm nut on it
as for draining the oil you drain it through the sump plus as you normally would
SOURCE: peugeot 406 coupe gear oil change
The oil filler neck is at the top of the engine, on the cam cover towards the RH side as you face the engine.
SOURCE: Random Overheating Problem on Peugeot 206
It sounds like your thermostat has gone bad and sticking close, Replace the Thermostat and Antifreeze. When replacing the thermostat, buy a fail safe thermostat so you will not have a overheating problem when the thermostat fails. Good luck and hope this helps. Keep me posted, be glad to help.
SOURCE: i have a peugeot 106 quiksilver, my oil light is
My daughters tacho and speedom are US on a peugeot 106 petrol 1.1, any ideas please
1,427 views
Usually answered in minutes!
Thank you Jeff.
Just finished checking injectors. I took all four of them to the service which can check injectors. There was no gas leaking, i.e. all of them were working ok and spraying enough gas when proper signal (impulse) arrives to them. They were also ok when just under preasure without impulse. Checking further.
×