Reset oil reminder systems - 2010 Honda Odyssey

How to reset the oil life and fuel filter reminder on a Chevy ...

? 1:59
www.youtube.com/watch?v=xdMZRlWum7Y
Feb 16, 2011 - Uploaded by briansmobile1 How to reset the oil life and fuel filter reminder on a Chevy truck .... Always reset the FUEL FILTER LIFE ...

May have to hold button by speedo for 10sec
Or hit that same button til oil life is shown then hold 10 sec
Or if it has the smart screen go thru options to find vehicle info and u can reset in there

Try turning the ignition to on and push the trip meter knob in and hold it till it resets.

SERVICE INTERVAL REMINDER
If equipped with a service reminder flag, the oil and oil filter service interval reminder flags will activate after every 7500 miles of operation. To reset indicators, insert ignition key into slots below indicator flags at lower right corner of instrument cluster. Push key in until reminder window changes from Red to Green.

How to Reset the Engine Oil Life System
The Engine Oil Life System calculates when to change the engine oil and filter based on vehicle use. Whenever the oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where the oil is changed prior to a CHANGE ENGINE OIL SOON message being turned on, reset the system.
Always reset the engine oil life to 100% after every oil change. It will not reset itself. To reset the Engine Oil Life System:
Display the OIL LIFE REMAINING on the DIC.
Press and hold the SET/RESET button on the DIC for more than five seconds. The oil life will change to 100%.
If the CHANGE ENGINE OIL SOON message comes back on when the vehicle is started, the Engine Oil Life System has not reset. Repeat the procedure.
Good luck and thanks for your question and I hope my suggestions help. burdfrenzy
Visit My eBay Store! http://stores.ebay.com/Pittsburgh-Joes-Pants-Nat

you need to reset it. by having key turn off and pushing the trip reset button on the dash. then turn key on and the light should blink and go out after a while keep holding button tell it goes out

1994-99 BUICK LESABRE
CHANGE OIL SOON Light
1. CHANGE OIL SOON light will come on when engine oil has broken down enough to require changing. After changing oil, reset oil life display.
2. To reset light, turn ignition on. Open glove box to access oil reset button. Press and hold oil reset button in glove box for at least 5 seconds, but not longer
than 60 seconds. The CHANGE OIL SOON light will flash 4 times to indicate light has been reset.

Look in your owners manual and go to the part that explains the different symbols on your dash. Look for that service reminder and it should tell you what page to go to to learn more about that. Somewhere there should be some wording to the effect that "When you have your car serviced by a certified Toyota dealer they will reset it for you. In the event that someone other does your maintenance then this is the procedure to reset......."

Oil Change Reminder Lamp: Service and Repair
Engine Oil Replacement Reminder Light
This light acts as a reminder to replace the engine oil.
This light will come on when the ignition key is turned to "ON" and will go off after about a few seconds.
When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about
12 seconds with the ignition key turned to the "ON" position. If you continue driving without replacing the engine oil, and if the distance driven
exceeds 8000 km(5000 miles), the light will come on. The light will remain on thereafter.
If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light
comes on, replace it as soon as possible.
Resetting the system
The system must be reset after the engine oil replacement. Reset the system by the following procedure:
1. Turn the ignition key to the "OFF" position with the odometer reading shown.
2. Turn the ignition key to the "ON" position while holding down the "TRIP METER" reset button.
Hold down the knob for atleast 5 seconds. The odometer indicates "000000" and the light goes off.
If the system fails to reset, the light will continue flashing.

Press the "step" button until the oil change interval comes up then press and hold "reset"