SOURCE: 96' sunfire changed engines 2.2 starts dies theft light comes on
The problem is the new PCM you installed does not have the correct VIN number of your car.
You may be able to relearn the VIN using the preceedure below, however, there is no gaurentee it will work. You may have to have a dealer reset the VIN for you by way of a scan tool.
1) Instert key into ignition and rotate to run position (do not try to start engine)
2) Leave the key in the run position for 10 minutes until security light stops flashing.
3) Turn ignition key to off position for 10 seconds ( no more, no less)
4) Turn ignition to run position again for 10 minutes until security light stops flashing and repeat step 3 and 4 for (1) more cycle.
The process is a security verification step for the VTD system. ( Vehicle Theft Deterent)
Give it a try, let me know.
Regards,
SOURCE: 1999 Sunfire 2.2L wont start
Try starting it with the shifter in neutral. You might have a bad
Neutral safety switch.
SOURCE: pontiac sunfire 97 replaced
Repair the anti theft system as car thinks you are trying to steal it.
SOURCE: Replaced the ignition switch in
need to chec wiring for flaws--something may be loose or no ground- bulb cud be burnt--try disconnectin the plug from the computer and cleanit--------also aftermarket parts can be an issue---send problem to [email protected]
SOURCE: what is the sequence in resetting the theft system
hey that guys soution below worked for me once then it wouldnt work again it might be the ignition its a recalled item call pontiac and they will be able to tell you if its been recalled or not.
287 views
Usually answered in minutes!
×