2004 Nissan Nissan almera tino Logo

Related Topics:

A
Anonymous Posted on Mar 21, 2012

How do i adjust handbrake on 04 nissan tino dci

Handbrake comes up too far ahd wont hold on a steep hill?

1 Answer

michelle gerry

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Jun 22, 2018
michelle gerry
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Jun 22, 2018
Answers
1
Questions
0
Helped
374
Points
1

How do I adjust the handbrake cable on a Nissan Almere 2004 please

5 Related Answers

Anonymous

  • 183 Answers
  • Posted on May 20, 2008

SOURCE: Nissan Almera Tino Right hand side

YEs but if you are going to do some secrifice on your luck of car model from front,

otherwise its impossible,

you can get this from older car dealer or service center,

TNX

Ad

Jonah Oneal

  • 14092 Answers
  • Posted on Jul 05, 2009

SOURCE: I have Nissan Altima, 2003 SE, V6 , manual. 127K.

sound like clutch contaminated with oil .you going up a steep hill your rear main seal probably leaking some .causing clutch to slip.

Anonymous

  • 57 Answers
  • Posted on Sep 22, 2009

SOURCE: Radio says Secure on Nissan Almera Tino (04)

Your radio believes that it has been stolen out of the car since battery power was lost to it (as a result of the car battery going dead). There should be instructions in the user manual on how to reset the radio.

Anonymous

  • 170 Answers
  • Posted on Jun 28, 2010

SOURCE: have got a new car key for nissan tino working

THERE CODED

John May

  • 111 Answers
  • Posted on Aug 02, 2011

SOURCE: how do i get service

Hi there.I think i can help u to turn off service alert, Its done in the following way:-
1.Switch ignition on ( do not start engine )
2.Switch radio ON.
3.Start engine.
4.Switch radio OFF.
5.Press and hold INFO button.
6.Turn volume control knob at least 30 clicks until self dianostic menu is displayed and an audible
signal is heard. ( while still holding the INFO button )
8.Using the circular dial ( Joystick ) select Confirmation/Adjustment and press centre of joystick
to ENTER.
9.Select Service and press ENTER.
10.Select Reset and press ENTER
11Press BACK button to return to main menu.
12.Switch OFF ignition
This should do the job, sorry it`s so long winded
Good luck John ( South Wales UK)

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I adj a hand break on my 2010 cleo disk breaks

Hi Jackie, 2010/2011 has drum brakes on the rear?
First up, check the rear brake shoes don't kneed adjusting, if you just adjust the handbrake, you end up with a handbrake thats not very good at holding you on a hill
0helpful
1answer

Smoking problems with nissan almera tino diesel 2.0

It is normal for a deisel engine to smoke some during hard acceleration.
0helpful
1answer

HANDBRAKE NOT HOLDING ON HILLs

You may need too adjust your handbrake cables,,or there stretched out to far,,,or you need 2 check your rear shoes/pads,,,hope this helps.
3helpful
2answers

I can't get my Gear Shift our of Park. The engine

Common problem.

In future, when on put it in park only AFTER the handbrake is applied. Ideally, foot brake, shift to N, apply handbrake, release foot brake, shift to park.

If the incline isn't steep have someone push car uphill while you gently move gearshift shift out of park. If its a steep hill, call a tow truck and move to a level surface. The parking pawl in the transmission becomes groved over time (and sticks) unless you use the handbreak as described.
1helpful
1answer

I just got my handbrake adjusted in my hyundai excel. whenever i pull up on a slope it still rolls back with the handbrake on

If the hill is steep or is covered with dirt or sand then you may not have a problem. Did you park there before and it held? Do you use the hand-brake all the time? Have there been times that you forgot to release the parking brake? When the shoes were adjusted were the shoes inspected before the adjustment? The tech. should have looked for problems.
1helpful
1answer
13helpful
1answer

Nissan Almera Tino Diesel 2.1 - Temperature control not working

Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.
0helpful
1answer

95 325 is e-brake doesn't fully engage

Adjustment will usually help, but try parking with front pointing down hill next time.(back in, apply E brake .) Emergency brakes usually hold better/well when vehicle front heading down hill. If it doesn't hold with front pointing down, then rear brakes need attention.
Not finding what you are looking for?

384 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...