How to Replace pickup Coil
SOURCE: I have 96 gmc 350 vortec. missing really bad. Ive
ou need to check compression on all the cly. do you know which cly is dead?
SOURCE: 1997 GMC Yukon won't start.
When it won't start, remove one plug wire and connect to a clean plug--lay the base on the block somewhere. Have someone try to start the engine. If you get regular blue sparks, the ignition is fine. Look for fuel problems. Make sure the check engine light works (bad bulb?). Why did the dealer think it was the fuel pump? Did they try to read the computer for any codes? Take the vehicle to Autozone for a free computer read. You could have an intermittent crankshaft/camshaft position sensor which can cause trouble for both ignition and fuel injectors.
Testimonial: "Sorry I didn't rate your suggestion sooner but we have a "situation" here I have been dealing with. Great suggestion, I'll try it if it acts up again."
SOURCE: how to replace the magnetic pickup coil on a 1995
Remove the cap and mark the rotor to the distributor housing so you reinstall it in the same place.Remove the rotor from distributor and put it on a vise.On the bottom where the gear is you will see a roll pin.Use a punch and hammer and remove it.Spray some carb cleaner and spray it down the shaft and twist and turn the shaft while pulling up on the shaft.This will make it easier to come off.You might have to keep adding carb cleaner til it comes out.Then install the new shaft,gear, and roll pin.Then reinstall the distributor and align it to your mark.Good luck.
SOURCE: how to replace fuel pump on 2001 gmc pickup 3/4
the fuel pump is inside the fuel tank. some techs just lower the fuel tank down, others remove the bed. personaly dropping the tank is harder, but lifting off the bed requires about 4 strong people.
235 views
Usually answered in minutes!
×