How to reset srs ml350

To reset the SRS light on an Acura Integra, pull down the SRS service connector. Unplug this connector so you have access to jump the harness. Start with the ignition OFF. Jump the SRS plug. Turn the ignition ON. The SRS light will come on then off.------------------------------------------------------------------------------
autel maxidas ds708

same as mine needs reseting did you disconect the battery if not it will show as a fault i forgot to disconect mine and the srs light is on all the time can buy a reset tool from ebay for less than taking it to garage and getting them to do it hope this helps

srs lights are the airbag light most common fault is a wire in the steering which atatches to air bag on steering wheel cannot remember what its called but i have just replaced mine for same problem

you can try disconnecting the battery again and see if the light goes away but usually when a srs light comes on the only way to clear it is with the 'sds' which the dealer has and sometimes the independent shops might have one too. Mercedes doesn't allow you to reset it from the vehicle due to it being safety related. when the srs light is on all your airbags and seatbelt etr's are disabled. if your vehicle has pre-safe then you will have to just drive it around til it relearns the steering angle sensor again. if that's the case it will say see owners manual in the display of the instrument cluster when showing the fault.

I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

you need to take it to volvo dealer to reset the light srs detects low battery voltage and turns on the light

the light will only go off if you fix the system or tell the vehicle you dont have a srs module but the dealers would have to do that.

TRY DISCONNECTING THE BATTERY TERMINALS FOR 5 MINUTES. BE AWARE THAT THE STEREO MAY HAVE A LOCK OUT CODE. RETRIEVE THIS CODE BEFORE YOU DISCONNECT THE BATTERY. HOPE THIS HELPS. BEST OF LUCK TO YOU.

disconnect the negative side battery cable wait 30 seconds put back then try this should of reset the system

I have 2002 Odyssey( 59000 miles without warranty). Several months ago the SRS light stayed on after I started the car. Some people said the dealers usually charge $ 80 to 95 to reset the light. Today I sent the car to dealer. After checking the car, they told me the car is under warranty, the parts and repairing are free.