You could replace the sensor or try disconnecting the DRL control module .What relay was replaced ? I see no relay on wiring diagrams or in service info. Replacing the Daytime Running Lamp (DRL) Ambient Light Sensor isn't hard . Just take the top dash pad off ,easy .
Removal Procedure
Remove the instrument panel (IP) upper trim. Refer to Instrument Panel Upper Trim Pad Replacement in Instrument Panel, Gages and Console.
Remove the security system LED. Refer to LED Indicator Replacement - Vehicle Security System in Theft Deterrent.
Twist the DRL sensor counterclockwise in order to remove the sensor from the IP upper trim.
Remove the DRL sensor from the wiring harness.
Removal Procedure
Remove the windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
Important: Remove the upper trim panel slowly, the retainer clips could possibly fall into the instrument panel.
Lift the instrument panel (IP) upper trim panel approximately 51 mm (2 in) and pull rearward to release the retainers.
Remove the DRL ambient light sensor. Refer to Daytime Running Lamp (DRL) Ambient Light Sensor Replacement in Lighting Systems.
If equipped, remove the sun load sensor.
Pull the windshield garnish molding from the A-pillar in order to disengage the retaining tabs and clips.
Remove the windshield garnish molding from the A-pillar.
Daytime Running Lamps (DRL) Control Module
Left side of the IP
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
Remove the instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
Slide the daytime running lamp module from the bracket.
Disconnect the electrical connectors.
SOURCE: Thermostat in a 2003 chevy venture van
the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down
SOURCE: rear brakes scrubbing on 1998 chevy venture van
Removal Procedure
Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from
being pinched between spring and shoe web or spring and backing plate.
Installation Procedure
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the
park brake actuator (3), and the adjuster actuator (1) properly.
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
SOURCE: Thermostat in a 2003 chevy venture van
no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.
SOURCE: How do you change a headlamp on a 2001 chevy tracker
there is a cover on the backside of these just pull of or twist off then replace the headlamp/ Please rate my response thank you very much
SOURCE: dont know how to reset or bypass gm theft system car is not starting .It tries and quits.
this is one way to reset it :
first make sure the battery is fully charged , then do the following:
key in the ignition but do not crank the motor, just leave it at the
ignition mode for ten minutes ,then turn it off POSITION for 5 seconds then REPEAT again 2 more times. at the 3 rd time youre gonna notice the ANTI THEFT light on dash to blink. when doing the last step , remove key , inserted again and turn on motor , good luck , AJ
1,266 views
Usually answered in minutes!
×