On the message center the low coolant light wont go off and now the low oil presure light wont quit comeing on how do i reset it
SOURCE: oil presure light comes on
After making sure that you used the propper oil filter and the correct grade of oil. inspect the Oil presure switch. if you see it wet with oil, replace it. given that you hear no internal engine noises, while you come to a stop and the light comes on. Then more that likely you have the wrong filter. please doubble check your oil level, 2.. Hope this helps
SOURCE: oil light stays on and coolant light
sounds like low oil pressure check oil pump, try thicker oil just to see
SOURCE: Now it want stop saying
the level sensor is located in the surge tank and is usually the reason for this message-it gets gummed up over the years and does not have the proper resistance readings, causing the display center to give that message. You can try removing the surge tank and clean it out (sensor is molded into the tank and has to be replaced as a unit). You can bypass it by cutting the connector at the sensor, and wiring in a 1800 ohm resistor, but then you will not actually know if your tank is low without visual observation. I have gotten used surge tanks in area junkyards to fix this problem, much cheaper than the factory OEM units (over $150). According to the field service manual, if the sensor is not the cause, the display center itself is defective, and is very expensive to replace-so try cleaning out the tank first, then look for a used tank-if that fails, the resistor is only 20 cents at a local Radio Shack.
450 views
Usually answered in minutes!
×