Wont go all the way up have to pull it the rest of the way up by hand the front window regulator went out before so i replaced it but im thinking the rear one may only need a motor when i bought the new regulator for the front window it came with a new motor so i still have the good motor from the front i can use from what i have read the front and back window motors are the same
If it fits go ahead. Just make sure you hook up the sires correctly and ..............................
SOURCE: front and rear motor mounts
Use a floor jack with a piece of scrap lumber to support the whole OIL PAN and lift the engine enough to remove the weight off of the defective motor mount, then replace the bad motor mount one at a time.
Note: There is 3 of these motor mounts and it might make it easier if you remove the bolt for the center mount so the engine will lift & lower easier to do the replacement.
SOURCE: my 2000 mitsubishi galant es went dead, motor will turn over but
do you have spark? How do you know if your timing belt is good? sometimes it doesnt break just shed the teeth which could be missing under the crankshaft. The best way to check is to have two people. have one try to start the car and see if the camshaft is actually spinning. The crankshaft will always turn but if the teeth are gone on timing belt this would cause the belt to stay in one position not moving the camshaft. so if you can remove the upper timing belt cover and do this quick inspection with someone that will tell you for sure. if it does look like it is spinning then by hand turn engine very slowly with plug coil wires removed. and make sure teeth are all there. It couldve jumped timing. (valve timing)
SOURCE: Starter on 2001 mitsubishi galant es 2.4L not working
dont know exsacly where is but should be where gear box meets engine and it sounds like the soliniod is stuck or gone or starter could be stuck in engine if manual put in gear and rock back and forward this may help relase it
SOURCE: 2001 mitsubishi galant trunk problem
yes a screwdriver or pliers depending if you can see the lever from where the key fits from .just turn it or open the lock itself
SOURCE: Replacing drivers side rear view mirro in Mitsubishi Galant 1997
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
2
3
Hold the rear of the headlight socket and turn it counterclockwise to unlock it. Pull the headlight socket and bulb from the headlight assembly.
4
Grab the bulb and pull it from the socket with a slight wiggling motion.
5
Pick up the new 9003 headlight bulb using a clean, lint-free cloth and line up its prong with the slots in the socket. Never tough the bulb with your bare hands, as the oils left by your hands can cause the bulb to burn out prematurely.
6
Slide the socket and new bulb into the headlight assembly and turn the socket clockwise to lock it into place.
7
Place the plastic cover behind the bulb and turn it counterclockwise to lock it into place.
8
Repeat Steps 1 through 7 for the headlight bulb on the other side of the Galant, if needed.
9
Read more: How to Put in a Headlight Bulb on a 2000 Mitsubishi Galant ' eHow.com http://www.ehow.com/how_8210819_put-bulb-2000-mitsubishi-galant.html#ixzz27iQwCdOe
382 views
Usually answered in minutes!
×