My 2001 mazda 626 automatic transmission will not move when i push gas; however if i start on a hill and get going it will kick in gear. In addtion the reverse works great as well as speeds on freeway are normal also the speedometer, is not working? already checked the speed sensor.
SOURCE: Idle Speed dies
I have a 1995 Mazada 626 V6 and i had a simular problem. My mechanic couldn't figure it out. My boyfriend did the usual checks also, but 1 thing extra he raised the idle to 1100-1200 rpm's from the 750-1000 it was at...well since then no problem.
good luck
SOURCE: Mazda 626 - Hard to shift into gear.
With any vehicle that has a hydraulic clutch, a worn master cylinder or slave cylinder will give this very symptom. First step is to check the fluid in the resivor. If it is low, you will want to check for fluid bypassing the seals. Be sure to check under the rubber dust cover as fluid can collect there and not be readily visible. Also, if the fluid in the resivor is dark colored, it is an indication of the internal seals going bad and you will need to replace the cylinders.
SOURCE: how can i fix my mazda 626 transmission range
That is right I was haveing the same problem with my 99 mazda 626 with 139,000 miles. It started shifting crazy. Come to find out that alot of the mechanics wanted me to think my tranny was on its way out! But I showed them different. It was the transmission range sensor switch. It cost like $40 at advance auto parts. I tried to clean the original one but the problem came back. So I replaced the swich and the problem is gone! Also they dont call it a transmission range sensor in the parts stores, Its called a Neutral saftey switch! Same thing, but different prices at the dealer and parts stores. The dealer wants $70 dollars for the part!
SOURCE: Mazda 323 fuel injection1994 accelerator problem
Try changing the fuel filter. If it clogs up the engine won't get the fuel it needs to run at wide throttle openings, the engine will ****** the timing, and you'll lose power. With less throttle the filter can flow well enough for the engine to run properly.
145 views
Usually answered in minutes!
×