Battery cable how can i remove the positive battery cable on a 2005 hyundai accent thank you

More images for Where is the cam sensor 2002 hyundai accent 1.5


Hyundai Crankshaft Position Sensor Removal - YouTube

? 3:42
https://www.youtube.com/watch?v=0YLYDU_5w8w
Jul 12, 2012 - Uploaded by richpin06a
Hyundai Elantra Crankshaft Position Sensor Removal.

Hyundai accent 2001 - YouTube

? 2:44
https://www.youtube.com/watch?v=fzqMNho3xIU
Nov 25, 2012 - Uploaded by mig dups
2000 Hyundai Accent GS turns over - no start. ... HyundaiCrankshaft Position Sensor Replace Timing Belt ...

it could be your transmisssion is not reading in park pos. have you looked at that.

the switch on your dome light is more common problem.
remove the switch and inspect for burn marks and corrosion
clean and install
the switch will have 12V Battery power at all time.and ground from the door switch.
second ground will be on the switch and clowse the circuit only with switch to ON position

First off remove the ground cable from the battery and at the body mount and CLEAN both area that the cables ground to
charge the battery fully and recheck if the car will start

Hope this helps and please don't forget to rate! Thanks!


Removal & Installation

1. Disconnect battery cable.
   
2. Remove the head lamp bolts.
   
3. Disconnect the head lamp connector.
   
4. Remove the head lamp.
   
5. Installation is the reverse order of removal procedure.
   

Headlight bulbs-2000-2005 Accent

Removal & Installation

1. Disconnect the negative battery cable.
   
2. Disconnect the sensor connector.
   
3. Remove the sensor retaining screws. Remove the sensor from its mounting.
   

To install:

1. Installation is the reverse of the removal procedure.
   

tps is located on throttle body across from accelerator cable make sure to mark the angle with a punch or mark so when install new one it will be in the same position
'
hope this helps
plz vote comment or reply if need more help

I removed the cable from the battery, then I turned the ignition key only to the ACC position. I then replaced the cable back on to the battery,and turned the ignition all the way on & my car started and the alarm reset itself. I didn't have to jump start it.

throttle position sensor is most likely the problem