2003 Hyundai Accent Logo

Related Topics:

Posted on Nov 05, 2017

The car is Accent crdi 2003 model. The mechanic found that the noice from the tapet is due to block of lifter. He took it outside and cleaned it with kerosine wery well and the action of the lifter spring got back in complete working condition. Will the noice of the engine be cleared if fitted? And is the cleaning if lifter effective?

5 Related Answers

Anonymous

  • 20 Answers
  • Posted on Dec 27, 2008

SOURCE: Noise From Tappets And Extended Cranking For Starting

the oil has dried in the lifters, because it hasnt been changed regularly, it sounds to me you have to replace the lifters

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jan 09, 2009

SOURCE: lifters on a 2000 hyundai Accent

3 valves per cylinder 4 cylinder engine, 3X4 is 12, so yes 12 is correct, no u don't have to change all of them, just the defective ones, the reason they want to do this is one of 2 things, there is a problem with the design of the original lifters and they want to update them, 2nd reason is they have been unable to isolated which lifter(s) are causing the tapping noise.

cy schousboe

  • 2002 Answers
  • Posted on Mar 24, 2010

SOURCE: my Hyundai Matrix with CRDI engine is spewing

It's true that turbos can't be rebuilt by the average mechanic. There is a lot of close tolerances and special tools required to repair a turbo. They have to be sent to a shop that specializes in that. I'm sorry for the bad news but thats it. Hope this helps.

Anonymous

  • 99 Answers
  • Posted on Jul 06, 2010

SOURCE: puff-puff sound comes after fuel pump repaired/cleaned !!!

It can happen some times their are few possibility for such problem to happen a few day ago we had see such problem in Hyundai Santro Xing this sort of problem can happen due to
1.Failure or less pressure flow from the Fuel Pump motor which is located in fuel tank.
2.It can happen due to inflated fluctuated current supply from Ig Coil in simple term Ignition Coil
3.It can happen due to faulty spark Plug where it time to need to change those faulty Spark Plug while Changing those spark plug do go for spark plug such a NGK or Denso this both company Spark Plug are or Good Quality they give your car the better performance, Mileage fuel economy efficiency .
make sure that if you are replacing Ignition Coil then better replace 3 things at a time Ignition Coil, Spark Plug, & Plug wire set.
& do remember to replace Spark Plug at every interval of 10000.Km.
in this case you better consult to an authorized Hyundai or KIA motors service workshop where your problem will be sort out hazard free.

Anonymous

  • 3 Answers
  • Posted on Jul 12, 2010

SOURCE: after 80000km done engine will have problem?

timely service from agency and fuel pump set changed will lend you finally with a barnd new car .

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hii I have accent crdi 2003 model it milage is v poor now a day its milage 15 and now reducing its 7 kmpl

run the fault codes for faulty sensors
check that the cat converter is functional and not blocking the exhaust system
0helpful
1answer

2003 hyundai accent 1.5L. tapping like valves need adjusted but engine has hydraulic lifters. Do the lifters need replacement?

Probably a combination of parts. Lifters and or rocker arms. Could be dirty lifters also. If your ready to change oil, what I do is get the engine to operating temperature. Pour a half quart of transmission fluid in and let it run 15 to 20 minutes. It's high detergent and helps clean out the lifters. If the lifters are tapping from dirt, this will stop the tapping or at least quiet it down some.
0helpful
1answer

Hi guys , I've an accent crdi 2003,engine starts not normally, Engine is totly overhall, but not good starting

take it back to who eve t=did the overhaul or check spark plugs spark plug cables, disrtibutor box
0helpful
4answers

Hi, I've an accent crdi 2003. In mornings engine

I would check the catlic converter to see if its not blocked, best thing to do is to go to a exhaust shop and they can do vacume test or tempreature test.
0helpful
1answer

My accent crdi engine was over hauled recently but severe black smoke was coming when accelerated what to do

Black smoke is from too much fuel. Possible coolant sensor problem??? You can have this tested quickly with a live data scanner from a mechanic.
0helpful
1answer

Hi, Am planning to buy a CRDI Accent 2003 model car, kindly suggest me what to look for before making a choice. My Contact #: 9886207635 Regards, Basanth Pathange

wheel archs rot from inside on mine and dont do high millage due to worn out ball joints ect theese cars are not bult to live forever
0helpful
1answer

Hyundi accent diesel car starts badly sometimes , it starts but has no engine power and black smoke comes from exhaust

Happened to me, too. On Hyudai Getz 1.5 CRDi (3 cylinder). It was just jammed butterfly (air regulator) where air is entering to machine for combustion. Due to low quality diesel soot is gathering on this butterfly and finally blocks it. However, the same problem could appear if air filter is full of dirt or blocked by dirt, or if there is computer problem in sending wrong information for combustion to engine.
4helpful
3answers

Replacing exterior door handle 2003 hyundai accent?

remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!
0helpful
1answer

Lifters on a 2000 hyundai Accent

3 valves per cylinder 4 cylinder engine, 3X4 is 12, so yes 12 is correct, no u don't have to change all of them, just the defective ones, the reason they want to do this is one of 2 things, there is a problem with the design of the original lifters and they want to update them, 2nd reason is they have been unable to isolated which lifter(s) are causing the tapping noise.
3helpful
1answer

Noise From Tappets And Extended Cranking For Starting

the oil has dried in the lifters, because it hasnt been changed regularly, it sounds to me you have to replace the lifters
Not finding what you are looking for?

80 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...