Make sure you remove exhaust downpipe as it obstructs lowering the sump. Removing the nuts at nearest the gearbox end of sump can require a thin socket as they're in a tight space. After all nuts removed then you need to break the rubber gasket seal which can be done CAREFULLY with a big screwdriver. After loosening the sump remove carefully so as not to damage the oil pickup pipe
Its so simple you should be able to do this with your eyes shut and dont forget to drain the oil first ,what goes on these cars is the oil pick up pipe ,its aluminium and snaps off so no oil to the big ends its a fairly common fault i have encountered
SOURCE: cant find the horn on a fiat punto elx
mm i had one once er maybe under the fenders or the grill n light area .. hope this helps ,,, it was 30 yr ago
SOURCE: Fiat Punto indicators
you need to change the flasher unit .... also check fuse # 24 on the fuse panel inside the vehicle. the flasher unit should be just under the dash on the steering wheel side... i have alot of information on that vehicle but i couldn't find where exactly the flasher unit is located.
Robert
SOURCE: oil pan replacement on fiat punto
this is not a big job - infact pretty straight forward -word of warning thou do not buy the replacement pan from e-bay - only tip i can give is once removed leave it standing for 24hours so all access oil is drained - makes it easier to fit new one also a cleaner job and less likely to leak - andy
SOURCE: fiat punto acceleration problems
nikki,
I had a similar problem with a 98 sporting. It turned out to be firstly the clutch had worn down to almost nothing and the fuel filter hadn't been changed in a good while so it got clogged. I would do the filter first. (located just under the drivers side near the rear wheel.
SOURCE: fitting a wing mirror on the passenger side of a fiat punto
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
1,422 views
Usually answered in minutes!
×