What is VDC - 2007 Infiniti FX35

There are many sensors that control the VDC. First check your battery to make sure it is fully charged. The VDC measures wheel rotation on each wheel independently. One that is low on air or wrong size can impact the VDC. Alignment of the wheels can cause VDC issues. If those are ok, check the individual sensors on each wheel to make sure they are intact and the wiring and connections are good.

Hi,
You need to get the VDC system repaired. Either the rear wheels are not working @ all or very inefficiently.

GL,
Td

Throttle position sensor.

Is VDC switch turned on? If not check brake fluid level

See if the following information helpful:
1. Keep an eye on the dashboard for the indicators marked "SLIP" and "VDC Off" which will tell you the status of the computerized handling system if handling isn't normal. "SLIP" will blink when VDC is operating. "VDC OFF" means the system is off. Turn the VDC system back on if the Nissan's handling is poor by pressing the "VDC Off" button until the light goes out.

2. Adjust your driving if "SLIP" comes on. "SLIP" means the road conditions may be slippery. The VDC aids in steering and stopping, but be careful, even if VDC is engaged.

3. Remove any aftermarket suspension parts like enhanced shock absorbers if the "VDC Off" light comes on and handling is bad. The VDC system is geared for stock equipment and tires only. Use winter tires or snow chains on snow-covered roads. VDC won't substitute for the correct winter equipment.

4. Don't drive on very inclined corners with high banks and leave the VDC switch on if the handling is poor with VDC on. The system can't operate properly in that environment. Disengage VDC, or avoid those kinds of roads.

VDC OFF light will always be off unless you turn it off (this is for traction control). The slip light should not be on however, unless you are driving in rain/snow and the VDC is activated.

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can try

VDC/ OFF light is still ON only ? or also SLIP + VDC/OFF ?

if VDC/OFF only u must check ur brake fluid status if both VDC and SLIP u still have problems with ur ABS module and steering wheel

to get rid of 4x4.while running, put your truck in N, foot on brake and change the selector out of 4 LOW. you should get indication on your dash, no 4X4 flashimg and back into 2WD. If the VDC light is on, its linked to your ABS so check your brake fluid levels. Good Luck