The cruise control fuse blew out then 4x4 wouldnt work
I have a o4 chevy colorado 4x4 and i lost my 4x4 in my truck its a 2.8l and when i push the 4x4 swich it blinks a few times and then gos back to 2wd. dose anyone know whats going on?
On my early 2006 Corado, the 15 amp fues would fail from time to time causing the 4wd light to blink and 4wd stop working. The problem was with the short 4 wire harness to the actuator and not with the actuator itself. I changed it and it still did not enguage. The wires and lower plug corode and degrade. If you have an honest Chevy dealer he will sell you the 2 foot long harness or you can buy an aftermarket lower plug and pigtail repair kit. The harnessis easy to get to by removing the aaair filter box and unplugging at the actuator. Took me about an hour including soldering on the 4 wires.No need to lift the vehicle.
×
SOURCE: cruise control doesn't work.
check for a vacuum leak i believe the cruise control runs off a vacuum
SOURCE: Chevy silverado keeps blowing fuses
sounds like a mouse has got in and chewed the cables,their is no easy fix from what i can think of but check all the wires and connections in case water has got into it,or snow if your in alaska.its fifteen years old now so its possible that some insulation has broken down or a wiring loom has chaffed somewhere underneath
SOURCE: 4-wheel drive won't shift into gear
I take it you have the manual t-case shifter on the floor. If so check all your linkages from the shifter to the t-case, if all appears well, simply disconnect the linkage from the t-case and see if it moves if it does your problem is in the shift mechanism in the t-case. if it still wont move even while disconnected clean and lube the linkage. If this still doesn't do the trick. replace your linkage
SOURCE: The brake lights on my 2004 Chevy Colorado are not
Look above your brake pedal and you will see your brake switch up along your brake pedal arm. It will either be between the brake arm and the firewall so when you brake it pushes the switch in. Or it will be between the dash and the brake arm so when you brake it pulls the switch out. Most likely this switch needs to be replaced
SOURCE: 92 chevy s10 4x4 4.3L manual transmission no 3rd gear
Hi:
Your transmission has 3 shift rails...
1st - 2nd
3rd -4th
5th- Reverse
If your 3rd gear doesn't work , you have an internal transmission problem, such as a syncronizer, or similar fail... There is not much you can fix, without removeing the transmission.
1,957 views
Usually answered in minutes!
×