Cars & Trucks Logo
Anonymous Posted on Feb 27, 2012

Diag code P0339

I am getting a P0339 code was getting both P0335 and 339 but I replaced the cks and the 335 code went away. The cel went off briefly the returned after about a mile test run. reran ignition switch test and only p0339 is showing up engine idles just fine until about 4000 rpm then sputters. Same when driving only at lower rpm.

  • Anonymous Feb 28, 2012

    I understand what the error code are that is why I replaced the sensor. I was hoping to find some help in solving the problem. But thanks Ken.

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 6 Answers
  • Posted on Feb 27, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Feb 23, 2012
Answers
6
Questions
1
Helped
3550
Points
19

P0339 is Crankshaft Position Sensor A CKT Intermittent
P0335 is Crankshaft Position Sensor A CKT Malfunction

  • Anonymous Feb 28, 2012

    Possibly a loose or bad connection, or bad ground if it is intermittent. If you replaced the sensor and it was ok for awhile, then came back as intermittent maybe the sensor was not bad and the problem is in the wiring or connection. Not sure if the sensor can be tested. Hope this helps.

×

1 Related Answer

Anonymous

  • 126 Answers
  • Posted on Sep 01, 2009

SOURCE: 2005 dodge grand caravan stalling when you put it

1 Inspect Carburetor Dirty and Improperly Functioning Carburetor. 2 Inspect Carburetor Incorrect Carburetor Adjustment. 3 Inspect Carburetor Worn, Faulty or Damaged Carburetor 1 Inspect Carburetor Worn, Faulty or Damaged Carburetor. 2 Inspect Mass Air Flow Sensor Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2helpful
2answers

Just bought a 2001 mazda mpv coolant fluid was low refilled it & disappeared (no leak under car, etc) car temp went up to H and the cel came on. turned car off found cracked hose by battery need diag

need diag Dani, Check the attached links,instruction and guides shows all cooling components in diagram and part #'s, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

2001 Mazda MPV Parts MileOneParts com

2001 mazda mpv cooling system diagram Google Search

Heater core coolant hose lines inlet and outlet location mazda mpv viewer...
0helpful
1answer

Crank, no start on 1994 honda accord EXi

you might need a fuel pump relay under dash 10 min fix/and your d4 flashing light bad transmission.
0helpful
1answer

What is P0339 code for a 2007 Honda Accord

This is a generic code applicable to all manufacturers. P0339 Crankshaft Position Sensor A Circuit Intermittent

Have the sensor replaced.

0helpful
1answer

When my car starts it stars briefly then shuts off. What could be the problem

I had this problem with my VW. The computer's anti-theft system did not recognize the chip in the key fob. I had to disconnect the car's battery to reset the computer. Only then would the engine stay running. I never found out why, the problem went away by itself.
Your problem could be something else, Is the check-engine light on? I assume that you can't tell since the motor won't stay running. The CEL will be lit when the ignition is turned on to verify that the bulb is not burned out. If it's a computer problem you may have to get the On Board Diagnostics code (OBD) read by someone with a reader.
0helpful
1answer

Jaguar xj8 3.2 1999.after the cold weather,the car starts no problem but an amber light is on.and the dash is saying reduced performance.any help.thanks

This us ussually signs of a week Crank Positioning sensor. Get it replaced. If you have a trouble code 335 or 336, that is the discription. (some diag ports have a 1 in front going by 1335 or 1336.)
0helpful
1answer

Check Engine Light comes on and off w/ P0304 code

this may be a defective fuel injector or a defective PCM (powertrain control module).
Not finding what you are looking for?

2,242 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...