Checked fuses & bulbs ... They are ok ??Checked fuses & bulbs ... They are ok ??
AnonymousMar 14, 2014
my lexus 300 es 1998 is showing code p733 c;3 shift solinoid is that covered in my power train warrenty?my lexus 300 es 1998 is showing code p733 c;3 shift solinoid is that covered in my power train warrenty?
AnonymousMar 15, 2014
how do you remove rear seat from 2010 lexus es 350how do you remove rear seat from 2010 lexus es 350
AnonymousMar 31, 2014
spot light bulbspot light bulb
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I know a website that has every info on all vehicles and vehicle problems(common/basic and technical both), with their solution In detail.. it's www.reliable-store.com
This may be right.I got this third hand.. works on later models. Above the area of the turn signal there will be a piece of black plastic that extends from the left side of the front of the car to the right. In this case if its the driver side pull up the plastic tab holding down the plastic strip in front of the battery directly above the headlight and lift it up. This will expose a screw that retains the front signal/driving light housing. Remove screw and carefully slide housing forward. Once out remove bulb and replace. This should only take 5 minutes, works on either side
- Place each hand against both sides of the plastic housing, and firmly
grasp and pull the housing towards you. It might not budge at first,
but it should move once you get a good grip on it.
- Pull the housing out just enough so that you can see the brake light
bulb and stick your hand underneath. Ignore the speaker wires.
- Pull out the old bulb from the socket (it plugs in/out). Wear rubber
gloves when handling the new bulb, and put the new one into the socket.
- Reverse the steps here to put the 3rd brake light back into place. Test out your brake light, and you're done" quoted from lexusk8 @ clublexus.com (great forum)
Open the deck lid (trunk) to better access the lights. There will be 2 of them. Recommend replacing both at the same time even if only one has failed. Generally sold in pairs anyway.
Directly above the license plate will be mounted 2 clear light covers. On the right side of each light cover you can see a small plastic rivet. Push in the center 1/4 inch with a small screwdriver then you will be able to pry out and remove the rivet without damaging it. This will save you from buying replacement plastic rivets for re-installation. Remove the light cover with the bulb harness attached.
The bulb harness requires a short turn counter clockwise to remove it from the light cover and the new bulbs snap into the harness. No twisting or screwing. Replace the bulb harness the same way and fasten the light cover back into place using the plastic rivet.
Saves time because both bulbs and light covers are exactly the same style, there is no left or right. Cheers!
in order to replaced the bulb, u go from inside the car (back Seat). The housing for the brake light will shift to the left (passanger side) then slide out, disconnect connector and replace buld
2006 f150
Checked fuses & bulbs ... They are ok ??
my lexus 300 es 1998 is showing code p733 c;3 shift solinoid is that covered in my power train warrenty?
how do you remove rear seat from 2010 lexus es 350
spot light bulb
×