Engine torque specs
SOURCE: Replacing head gasket on 1995 honda civic, require torque specs and secquence
7.3 ft.lbs Go from middle, to back right, to back left, to front right, to front left. if your standing in fron of your header. 11 or over usually shears the bolt.(if you have stock bolts)
Make sure you dap some rtv on the sharper 4 corners of the gasket where the cam seals are.
James Mac
SOURCE: honda prelude si 1991
I had the sme problem with my 1992 prelude si. The problem with mine was that the intake manifold gasket was leaking horribly. The idle would go up and down just setting there, but when I held the brake long enough it stopped. An easy way to see if it is the gasket is get WD40 or Brakleen or soemthing like that, and spary it where the intake manifols bolts to the block. If you hear a change in the idle speed (faster or slower) just change out the gasket.
SOURCE: transmission dipstick
Look on ths side the transmission is located on, and look for a yellow handled dipstick. It should be on the front of the transmission somewhere
SOURCE: 1991 honda prelude speedometer not working,what is
your cable is either broken or can loose on your trans axle or behind your instrument cluster. Check those first. cost ????? not sure
SOURCE: Torque specs for 96 Honda Accord 2.2L
the main bearings bolts is to 1st step 30Nm or 22lbs ft and the last step is 75Nm or 54lbs ft in this tighten secuence. 9 3 1 5 7 on the top bolts and........ ........ ........ ... 8 6 2 4 10 botton bolts and the connecting rod 45Nm or 34 lbs ft i hope be help you
225 views
Usually answered in minutes!
×