Why dnt my truck get fire to the motor? - 1995 Dodge Dakota

get it scanned for fault codes

could possibly be
to get the correct firing, order in your browser page search bar type in- firing order for dodge regal -- and you will get pages and diagrams to help you get it right

Google firing order for your vehicle . Then the order is relevant to your coil pack which should have the numbers of what cylinder the terminate at.

Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

sound like a blown head gasket, Chemical fixas dont usually work. You should replace the head gaskets and have the heads milled.

First make sure you have the right amp fuse,if its good something is amiss in the circuit. The wiring should be checked along with the components in the circuit to determine if there's a short or other problem.
For example if the fuse blows in a motor circuit (heater blower motor, cooling fan motor, power seat or window, electric fuel pump, etc.), it often indicates a shorted motor. If a fuse in a light circuit blows, look for wiring or connector shorts
GOOD LUCK

Hi i had the same prob with my 99 alfa 156. It seems that there could be a problem with the air sensor on the induction kit. If you remove the sensor and use some brake cleaner to clean it. Use gloves on dnt touch the sensor its self, and dnt use a rag or a cloth on it. Install it again after 5 or 10 mins and start the car up. It should work fine. If it does the trick check your air filter as it might be damaged and not working properly. I checked mine and found there was no filter in it at all. I found a cone filter works better for the car.

make sure you put the same name brand of plugs in it also make sure that your wires are in the right firing order on the distributer cap your local automotive can give you this if you dnt have it

here

Have you checked for compression?