1995 Oldsmobile Cutlass Supreme door lock

SOURCE: 1995 cutlass supreme transmission

It physically will fit and bolt up,but there are many different ratio,and drive and driven sprocket tooth counts,different final drive ratios,all monitored by the computer with electronic speed sensors.If the trans from the 95 has a different ratio than the 93,the computer will set gear ratio error codes,and possibly put the trans in a failsafe mode,stuck in 2nd or 3rd gear.On the transmission case,down by where the passenger side axle would go in,is a thin metallic tag,maybe 2"x 3",and it has bar codes,and also a series of numbers and letters.The numbers and letters,large cap,are the final drive gear ratio code.They should match on the two transmissions in question.

SOURCE: 1998 Oldsmobile Cutlass Supreme Blower Motor

It's not to hard to do, just have to lay upside down in your pas. floorboard, remove plastic panels under gloove box with small nut drivers,(can't remember size) then there are three hex head screws holding on the blowerplus the wireing connector, anf it has a wierd rubber gasket, hope this helps.

machinehead2

• 14 Answers
• Posted on Jan 10, 2009

SOURCE: 1994 oldsmobile cutlass supreme will not start.security flashes

Sounds like a RFID issue. Your key most likely has a chip inside of it. Most of the time people will have multiple keys on their key chain that can cause interference with the receiver in your steering column. Try using the one ignition key to start.

SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all

maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.

SOURCE: 1986 Oldsmobile Cutlass Supreme vacuum hose

Ok sent you this the engine you have to specify that engine has to help you. Thanks

Testimonial: "good job getting info. and real quick too"