I had a shop replace a ball joint on each side. The calipers were both off the truck durning the repair. They must not have refilled the brake fluid. The light came on, the fluid was low when I stopped 300 miles down the road. I topped the fluid off and the brakes work, but the light stays on. Thanks
My info says to disconnect and reconnect abs control module. Passenger compartment, access after removing right hand cowl cover. Or disconnect battery ground cable. I have to tell you I don't like disconnecting battery cables, sometimes that causes more problems than you already had. Sometimes it doesn't cause any problems??
SOURCE: 2000 durango brake problem
The pads are most likely glazed, and therefore aren't working well. Regardless of how much life they have left, replace them and your braking issues are likely to go away.
SOURCE: What is a Code 84
Hello
Welcome to FY
I would check your speed sensor located on the rear end this is on top of the housing this will throw that code too.
RD
SOURCE: How to change ball joints on 1997 2500 4x4 dodge diesel
Not hard, you'll need a special socket to get the axle nut off and getting the bearing out of the spindle is usually a real chore. Since it sounds like the spindle is already out, you might be able to do it in a press.
To get the ball joints out of the spindle, drive them out with a hammer. If you need to get the ball joint out of the axle, strike the axle next to where the ball joint taper is with a large hammer. That will usually distort the axle material enough (for a split second) to let the tappered section loose.
SOURCE: Changing front ball joints on Dodge 2500 2005
can it not be done without removing the hub ?? dont think you can get hub off without removing the track control ball joint?do you have the right tools??
SOURCE: had u joint repair on 98 dodge ram 1500 v8 now have trans leak?
I just replaced my front ujoint for the 2nd time and yes when you pull the outer axle to replace the u joint and then reinstall the axle it seems to dislodge or screw up the seal. the 1st time i had a shop do it and they fixed the seal but now its on me
VALVE CENTERING PROCEDURE
336 views
Usually answered in minutes!
×