1996 jeep grand cherokee loredo

Video help

https://www.google.com/search?q=1996+jeep+grand+cherokee+security+reset

..

Pass front door, Lock-Unlock X3 turns it off...M... (EVIL ZJ)

the dash has to be remove on jeeps and dodge,it's alot of work and thakes about 4 hours to replace good luck.

ok use door locks lock every thing then go unlock the tail door then unlock passenger door that should reset it

BCM is under the left dash near the steering column....



Hope this helps.

after hooking up the battery go to the drivers door and use the key to lock and unlock the door

The 1996 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE.

Also, remember that here can find the Jeep Grand Cherokee Service & Repair Manual.
Hope help with this.

lock & unlock the tailgate lock cylinder

problem in security system its in shut off mode.not a home fix dealership has to repair it because they have to use a computer to reset fix the car pcm security system.

they have crankshaft sencers on the transmission on jeeps. it would be up high on the drivers side on front of transmission. they will cause it to not get fuel or fire and can run then quit.