About that Vette you are going to see on Saturday, check the trans oil. Look for anything unusual in the color. Smell it and see if you detect any strange odor like a burnt smell. Also, check the engine oil carefully, too. Look at the brake pedal very closely. It can tell you a lot about how the drive operated the car. Was he ******* the brake? Look closely at the lower part of the quarter panels and see if there is any damage like large nicks or dents. Take a look at the radiator front - is it clean without any damage? These are some of the areas you can check to get a better idea of the condition and use of the car.
SOURCE: torque specs
Hello mikemcgee63, my name is JShreader. Thank you for choosing fixya.com.
The Torque Specs for the Thermostat Housing are 10 Nm (89 inch lbs.).
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!
SOURCE: 93 Corvette bucks, misses, and backfires about 2.5K RPM
Has the Optispark distributor cap been replaced yet, if not have it replaced.
SOURCE: whining noise from front of 2003 impala.higher
Apparently the whine is car speed related and not engine speed. I'm surprised that you didn't say anything about checking the wheel bearings?
SOURCE: whining noise from front of 2003 impala.higher
Sounds like it could be the wheel bearing. Jack up the car, and see if the tire feels loose when pushing in and out at the top and bottom of the tire. That;s the most obvious way to check. But many times, the bearing is tight, but still bad.
SOURCE: I'm trying to locate the vats module in a 90 corvette.
You can easily bypass the entire VATS system. There is a clear write-up here on this website:http://newrockies.ca. This was the only thing that saved my Park Avenue with the same security system.
71 views
Usually answered in minutes!
×