1995 isuzu bighorn inport ,problem with automatic gearbox will drive for a few mile and stops turn off the engine and restart after a few mins moves a couple hundred yards and no drive again ,changed oil and cleaned filter in the box and replaced the oil in trans box at back any help on this problem would be appricatiated thankyou

SOURCE: hey i have an isuzu bighorn 3.2 v6 it has a trans

Code 61 relates to airflow sensor having a broken or short in the hot line. Hope this helps, please leave comment.

Steve Hurc

• 459 Answers
• Posted on Jul 29, 2009

SOURCE: Speedo stopped working

check wire/wiring connector on right rear section of transfer case.
disconnect wire connector and remove and inspect gear drive for worn teeth including gear inside case.

SOURCE: check trans light on

there are 2 possible problem and solution. 1st check your RPM sensor located in the transmission.(less expensive part). if this does not work. got to option 2 which is the computer box, try to consult an expert computer box technician to repair it or buy a new comp box. but before buying... be sure all electrical connections are good and no additional accessory are connected to the wirings.bad connections and circuits may lead to damage comp box.

SOURCE: I want to change my

That's a lot of work, Have you thought about swaping vehicals?

SOURCE: what size battery do i

Specifications
12V 113Ah
Cold Start Marine Cranking Amps: 1000A
Deep-cycle & Starting
Sealed Lead Acid

500 Cycles

3 Years Guarantee

Dimensions(mm)
325 x 172 x 220 (incl. terminals)